Nayascm - 24-4-2017 at 20:12
I am a beginner in Electronics and I do need a rundown on things to check to find out where the fault is in the MS-HS Scilogex Hotplate stirrer, as no
power is seen at all when plugged.
Fuse and power output to the PCB is checked with multimeter and V reading is 120 V between L and N at the PCB soder.
Further not so sure where to check and how - any details or guidance will be very much appreciated.
j_sum1 - 24-4-2017 at 22:07
Hard to tell. It might be easier if you post some photos of the innards of the thing.