Pages:
1
2 |
Loptr
International Hazard
Posts: 1348
Registered: 20-5-2014
Location: USA
Member Is Offline
Mood: Grateful
|
|
You might want to check this out in regards to the methylenation.
Attachment: ja00444a030.pdf (210kB) This file has been downloaded 777 times
[Edited on 13-5-2015 by Loptr]
|
|
drenchedingold
Harmless
Posts: 13
Registered: 11-5-2015
Member Is Offline
Mood: No Mood
|
|
Sorry brother couldn't open it. I'll try downloading a new pdf
|
|
Loptr
International Hazard
Posts: 1348
Registered: 20-5-2014
Location: USA
Member Is Offline
Mood: Grateful
|
|
The point of the paper was that the time requirement is lowered and yield is drastically increased with the usage of DMF with potassium fluoride, or
even better, cesium fluoride.
I also seem to recall reading an inert atmosphere isn't required for this particular procedure, but you want to ensure everything is very dry.
[Edited on 14-5-2015 by Loptr]
[Edited on 14-5-2015 by Loptr]
|
|
skip
Hazard to Self
Posts: 54
Registered: 16-5-2015
Member Is Offline
Mood: No Mood
|
|
how is done ?
Quote: Originally posted by Boffis | I have used propane as an oxygen shield when preparing sodium cyanide from anhydrous sodium ferrocyanide and metallic sodium. The small amounts of
impurities in commercial propane fuel are not a problem. You just have to remember its not so inert in contact with air but if you are flushing a
reaction vessel you can always run the exhaust gas through a bunsen burner to burn it off. |
like to know more about using sodium ferrocyanide and metallic sodium to produce NaCN. thanks
|
|
Loptr
International Hazard
Posts: 1348
Registered: 20-5-2014
Location: USA
Member Is Offline
Mood: Grateful
|
|
If you really have to ask, the HCN vapor will likely kill you.
Not something to take lightly.
We had a member die a while back due to similar preparations.
The NaCN preparation on YT is actually of the member that died.
|
|
skip
Hazard to Self
Posts: 54
Registered: 16-5-2015
Member Is Offline
Mood: No Mood
|
|
Ive already done it lots of times on a molar scale .I was wanting to know how elemental sodium is used in the process. I always used sodium hydroxide
. Have distilled hydrocyanic lots of times and never had a problem. Why does alot of people here always assume some one with a couple posts is dumb
as dirt.
[Edited on 22-5-2015 by skip]
|
|
Crowfjord
Hazard to Others
Posts: 390
Registered: 20-1-2013
Location: Pacific Northwest
Member Is Offline
Mood: Ever so slowly crystallizing...
|
|
The method of reducing ferrocyanide with sodium is posted on this forum. I think it is at or toward the end of the "Preparation of cyanides" thread,
under Chemistry in General. Search and you will find.
|
|
skip
Hazard to Self
Posts: 54
Registered: 16-5-2015
Member Is Offline
Mood: No Mood
|
|
Sorry to hijack the thread. Thanks crowford I see now, I will stick to my way. Thanks again. Kind regards.
|
|
Pages:
1
2 |