joniaguis
Harmless
Posts: 15
Registered: 2-5-2009
Member Is Offline
Mood: No Mood
|
|
Entropy calculation
I need some assistance over the following question. I don't know exactly which equation I have to use.
Determine the entropy change when one mole of a liquid (bpt 356K) is heated from 298K up to 428K given the following information:
Cp of liquid: 45 cal/mole/degree
Cp of vapour: 10.8 + 3.35 x 10^-2 T + 0.95 x 10^-4 T^2 cal/mole/degree
heat of vapourisation: 4405 cal/mole
|
|
JohnWW
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2849
Registered: 27-7-2004
Location: New Zealand
Member Is Offline
Mood: No Mood
|
|
This question really belongs in the "Beginnings" section. A clue: You can fairly readily calculate the enthalpy change at constant pressure, by adding
the heat of vaporization to the increase in heat content on heating the liquid to the boiling point by multiplying the Cp (liquid) by the temperature
change, and to the subsequent increase in heat content of the vapor by integrating the formula for the Cp (vapor) from the b.pt. up to the final
temperature. Then you can apply the Gibbs equation:
(delta)G = (delta)H - T.(delta)S, where (delta)S is the change in entropy, (delta)G is the change in Gibbs free energy, and (delta)H is the change in
enthalpy. See also Perry chapter 4.
|
|
DJF90
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2266
Registered: 15-12-2007
Location: At the bench
Member Is Offline
Mood: No Mood
|
|
I've taken the liberty of providing a worked answer. Hopefully you have a decent understanding of calculus and thermodynamics in general.
Attachment: Entropy Solution.pdf (35kB) This file has been downloaded 524 times
|
|
joniaguis
Harmless
Posts: 15
Registered: 2-5-2009
Member Is Offline
Mood: No Mood
|
|
I tried it yesterday and Ive got 26.81cal/mol as answer. I try to analyze the question and see where I could have gone wrong.
|
|
joniaguis
Harmless
Posts: 15
Registered: 2-5-2009
Member Is Offline
Mood: No Mood
|
|
found the mistake. Thanks a lot mate.
|
|
Nicodem
Super Moderator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
I have no idea what this thread was doing in the Energetic Materials section. Moved to Beginnings section...
|
|
Nicodem
|
Thread Moved 4-5-2009 at 00:08 |
DJF90
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2266
Registered: 15-12-2007
Location: At the bench
Member Is Offline
Mood: No Mood
|
|
No problem. My solution is correct yes? That is very encouraging especially as I have exams in 5 weeks...
|
|
joniaguis
Harmless
Posts: 15
Registered: 2-5-2009
Member Is Offline
Mood: No Mood
|
|
same here exams too. That was a past paper question. good luck with yours.
|
|