Chemguy5
Harmless
Posts: 27
Registered: 11-7-2018
Member Is Offline
|
|
Designing a sodium aggregate reaction cell
I want to improve on Nurd rage's soup can reaction cell in which he reacts sodium hydroxide and magnesium turnings to create sodium metal aggregate. I
have access to welding equipment and all kinds of tools and materials to fabricate some sort of reaction vessel. Now as far as I know to improve the
yield of sodium I would need to limit the amount of oxygen getting into the vessel as to not oxidize the sodium as it forms. I also have access to
argon gas which I'm thinking I can incorporate into the reaction vessel some how giving it a continuous stream of gas as to create an inert atmosphere
but this is the tricky part. I know all this isn't necessary and I can get good yields just using a soup can but I have some free time on my hands and
I would like to attemp coming up with a design and would like to get some ideas from some of you here.
My idea is to take a large hollow cylinder some what bigger than a soup can so I can scale up the reaction, I will cap off the bottom by welding it to
a sheet of metal. I need some ideas on how I should create the lid. I obviously need pressure to vent out the lid as the reaction progresses without
letting oxygen back in. I was thinking of just drilling a small hole in lid to release pressure and also welding a small metal tube in the side of the
vessel hooked up to an argon tank and some tubing and giving it a constant supply of argon. Is it neccasary to pump argon throughout the entire
reaction or only after the initial reaction is over?
Any help would be great thanks.
|
|
|
MJ101
Hazard to Self
Posts: 82
Registered: 14-6-2018
Member Is Offline
Mood: Always Sunny
|
|
Since you have welding gear, Perhaps you can take some ideas from the design of a pressure cooker.
I would suggest a pressure gauge of some kind, but the NaOH might eat it. Not sure.
Best of luck with your project. Please post pics when it's completed. 
|
|
|
Vosoryx
Hazard to Others
Posts: 282
Registered: 18-6-2017
Location: British Columbia, Canada
Member Is Offline
Mood: Serial Apple Enjoyer
|
|
This sounds like a great project.
Yes, please post pics both at completion and during construction/various testing phases.
"Open your mind son, before someone opens it for you." - Dr. Walter Bishop
|
|
|
walruslover69
Hazard to Others
Posts: 233
Registered: 21-12-2017
Member Is Offline
Mood: No Mood
|
|
How do you plan on opening it? It sounds like you would have to cut it open to get the contents out.
If you wanted to you could just attached an oil bubbler or just a cheap one way check valve that you could attach to a tube bought at any major
hardware store.
I think it would be much easier for you to do it in a closed container so you didn't have to worry about rigging a gas release. If I were doing it I
would get a 3-4 inch diameter pipe with screw cap ends and just screw iron endcaps to each end so u can easily unscrew and open it when the reaction
is done. If you use sodium oxide instead of hydroxide then there will be no gas evolved therefore you could do it in closed system without too much
pressure being generated.
If you have a high temp forge/furnace then you can make your own sodium oxide by heating sodium carbonate.
|
|
|
XeonTheMGPony
International Hazard
Posts: 1640
Registered: 5-1-2016
Member Is Offline
Mood: No Mood
|
|
I'd use a spring loaded check valve on the lid to vent pressure but keep atmosphere out, then vacuum break with the argon as the reaction will make
it's own sweeping gas.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
