soma
Hazard to Others
Posts: 297
Registered: 31-7-2010
Member Is Offline
Mood: No Mood
|
|
Mg(OH)2 impurity
After reacting MgSO4 with NaOH and thoroughly washing with water, I then reacted the Mg(OH)2 with ascorbic acid. The liquid magnesium ascorbate was
slightly cloudy.
I'm wondering what the impurity could be. There was enough water to completely dissolve the ascorbate and the pH was around 6.2 so there shouldn't
have been any Mg(OH)2 unreacted.
|
|
|
happyfooddance
National Hazard
Posts: 530
Registered: 9-11-2017
Location: Los Angeles, Ca.
Member Is Offline
Mood: No Mood
|
|
When you neutralize a base (esp. one which isn't very soluble) with a weak acid, it usually takes a little heat and a fair bit of time to reach
equilibrium. I make magnesium citrate from the carbonate and citric acid on the regular and I have this problem.
Edit: Even when neutralizing CaCO3 with HCl, one needs to use an excess of acid and a fair bit of time/stirring to ensure complete conversion of the
carbonate. I have had solutions stirring with a pH of 3, for an hour or more, that still have traces of carbonate! Believe it or not...
[Edited on 6-29-2018 by happyfooddance]
|
|
|
Boffis
International Hazard
Posts: 1867
Registered: 1-5-2011
Member Is Offline
Mood: No Mood
|
|
You may have a little magnesium carbonate in the initial precipitiate due to the presence of a little carbonate in the sodium hydroxide. Magnesium
carbonate MgCO3 is actually rather difficult and slow to dissolve in weak acids even when very finely divided and ascorbic acid is a rather weak acid.
Add a little filter aid such as cellulose or diatomaceous earth and filter or just heat a little as happfooddance suggests.
|
|
|
soma
Hazard to Others
Posts: 297
Registered: 31-7-2010
Member Is Offline
Mood: No Mood
|
|
I've used MgCO3 in the past to make the ascorbate and the only problem was that there was carbonation of the ascorbate that slowly evaporated and so
the pH would go too high. But the solution was always clear. I also used MgO which also gave a clear solution although it would take maybe 20 minutes
to complete. I blend the ascorbic and carbonate, oxide, or hydroxide in a blender and then let it sit.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
