Aqua-regia1
Harmless
Posts: 33
Registered: 9-12-2006
Member Is Offline
Mood: No Mood
|
|
preparation of p-phenylendiamine
Have somebody ever synthetised pure (not dark coloured) p-phenylendiamine? How it can be prepare pure this one for synthesis? Thanks
|
|
|
Ozone
International Hazard
Posts: 1269
Registered: 28-7-2005
Location: Good Olde USA
Member Is Offline
Mood: Integrated
|
|
"Pure" p-phenylenediamine will become colored on storage with exposure to light, O2 and/or heat. These are oxidation products and will be found in
most aromatic amines that have been stored for any length of time (particularly, aniline).
Either you distill the colored material (which is a pain w/high boilers) or, preferably stir with decolorizing carbon (Darco, Norit, etc.) and filter
though celite in a buchner funnel.
One synthetic route could start with aniline. First, the aniline is solubllized into water as the hydrochloride salt. To this is added norit with
stirring. This is filtered through celite and rinsed with water. To the filtrate is added acetic anhydride and sodium acetate with stirring. Cool the
mixture and collect the acetanilide (recrystallize if you wish). Second, the material is nitrated with H2SO4/HNO3 slowly and with cooling so as to not
exceed 5°C at any time. The reaction is quenched with ice, carefully neutralized and the product, p-nitroacetanilide is recovered. Third, to this is
added dilute HCl (aq) and this is refluxed for 1-2hr to hydrolize the amide. This yields p-nitroaniline. Fourth, to this is added tin granules and
HCl. The mixture is shaken and cooled (ice) until the reaction is complete. This is neutralized w/NaOH, rendered basic, and extracted into say, DCM.
The Solvent is removed under vacuum to yield 4-aminoaniline, free base.
All of these reactions are fundamental and taught at the sophomore level in University courses.
Cheers,
O3
-Anyone who never made a mistake never tried anything new.
--Albert Einstein
|
|
|
unionised
International Hazard
Posts: 5126
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
You can clean the stuff up quite well by dissolving it in dilute HCl, washing with ether (which takes out some of the black stuff) and reprecipitating
the base with NaOH soln. Not as good as distillation, but much easier.
|
|
|
Aqua-regia1
Harmless
Posts: 33
Registered: 9-12-2006
Member Is Offline
Mood: No Mood
|
|
Thanks Dear Sirs
|
|
|
Nicodem
Super Moderator
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
The black stuff (polyanilinic dyes, quinones and the like) can be removed by recrystallization if you discolor with active charcoal. However, vacuum
distillation is a considerably more rational and practical solution.
|
|
|
Sergei_Eisenstein
Hazard to Others
Posts: 290
Registered: 13-12-2004
Location: Waziristan
Member Is Offline
Mood: training
|
|
Is it more practical? Personally, I'm not inclined to leave a distillation setup unattended. I'm usually doing something nearby to keep an eye on the
process. As such, it requires some time. Discoloration/recrystallization does not require the same amount of time, and drying the substance usually
doesn't require special attention either. So, from my personal point of view, I'll choose a recrystallization over a distillation as much as possible.
damnant quod non intelligunt
|
|
|
Nicodem
Super Moderator
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
I had more like a kughlrohr in mind, not necessarily an actual distillation setup which would be more difficult to use since the distillate solidifies
and easily clogs the vapors path. In my experience with compounds of that type, recrystallization with charcoal generally works if there is little
polianilinic crap inside. But if there is a lot one recrystallization is not enough and lots of charcoal needs to be used. The recovery also sucks in
comparison with distillation.
|
|
|
unionised
International Hazard
Posts: 5126
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
So, if you happen to have a kughlrohr handy it's earier to use it. I daresay it is, but for those of us struggling by with more moderate kit I think
Sergei is probably right.
BTW, IIRC recrystalising PPD as the HCl salt from water/alcohol mixture works well and the acid conditions retard oxidation. For some purposes the
salt is just as useful as the free base.
|
|
|
Nicodem
Super Moderator
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
| Quote: | Originally posted by unionised
So, if you happen to have a kughlrohr handy it's earier to use it. I daresay it is, but for those of us struggling by with more moderate kit I think
Sergei is probably right. |
But it was just because I thought Aqua-regia1 had no access to vacuum distillation equipment that I suggested him to recrystallize. Sergei's reply was
about my claim that vacuum distillation is a "considerably more rational and practical solution". It is more rational because you get a purer product
with an excellent recovery and practical because it takes less work (which is important for lazy people like me) and no solvents. The most unpractical
part is in taking out the large chunks of crystals that form from the distillate.
| Quote: | | BTW, IIRC recrystalising PPD as the HCl salt from water/alcohol mixture works well and the acid conditions retard oxidation. For some purposes the
salt is just as useful as the free base. |
That indeed slows down the oxidation but recrystallizing the hydrochloride does not remove the polyanilinic crap that is already present. I do not
know if this is true for p-aminoaniline, but in my experience it is true for certain other anilines that tend to colorize by prolonged air exposure.
Those annoying polyanilines just tend to stick together with the original anilines, whether as free bases or hydrochlorides (these annoying dyes also
dissolve in acidic media and can not be washed away). Recrystallization with active charcoal in non polar solvents is in my experience most efficient
if distillation is not an option. If the recrystallization is done in water or water/alcohols the active charcoal is not equally efficient, but it is
still better than nothing.
…there is a human touch of the cultist “believer” in every theorist that he must struggle against as being
unworthy of the scientist. Some of the greatest men of science have publicly repudiated a theory which earlier they hotly defended. In this lies their
scientific temper, not in the scientific defense of the theory. - Weston La Barre (Ghost Dance, 1972)
Read the The ScienceMadness Guidelines!
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
