Grantr
Hazard to Self
Posts: 57
Registered: 19-9-2015
Member Is Offline
Mood: No Mood
|
|
ETN pressed density
Wikipedia (I know not the best source) states ETN compressed to 1.6 grams/cm3 has a VOD of 8000 to 8100 meter per second.
If I have a 1/4 inch inside diameter tube cut to 1 inch, I have .804 Cm3. So pressing 1.29 grams of ETN in this space will give me the density needed
for 8000 Mps.
What if the ETN is pressed to a higher density? Will the VOD go up or stay the same?
Does crystal size matter when pressing?
|
|
|
greenlight
National Hazard
Posts: 742
Registered: 3-11-2014
Member Is Offline
Mood: Energetic
|
|
I always thought it was slightly lower, something like 7900 m/s but I am probably wrong.
For every 1 Cm3 you should have 1.6 grams of ETN so yeah that sounds right:
0.16x10=1.6 grams
0.16x8=1.28 grams
As for pressing to a higher density, I am fairly sure explosive VOD will continue to rise as the density increases until a point is reached where even
if you press the explosive to an even higher density, the velocity of detonation will still remain the same or could even cause a failure to detonate.
In some explosives such as Mercury fulminate, the explosive can even be pressed to such a high density (I think around 4.4+) that it becomes dead
pressed and just burns instead of detonating when flame is applied to it.
Small crystals like ones you would use to prepare plastic explosive with would be least messy and easier to press to a high density than the fluffy
low density powder. Fluffy crystals give a less dense PE than recrystallized product so I am sure they would press to a higher density more
efficiently as well.
Be good, otherwise be good at it 
|
|
|
Grantr
Hazard to Self
Posts: 57
Registered: 19-9-2015
Member Is Offline
Mood: No Mood
|
|
Thanks Greenlight.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
