The Volatile Chemist
International Hazard
Posts: 1981
Registered: 22-3-2014
Location: 'Stil' in the lab...
Member Is Offline
Mood: Copious
|
|
-Naphthalene Usage-
Normally at a lack for stuff, I found two good sized containers of lighter fluid, or something like that (I'm at school now, so I can't check it's
purpose). What caught my eye was that it stated it was naphthalene. It was a liquid, so I don't know what it all was, but are there any uses for
this/any common reactions I could do with it? Wikipedia, my normal source for reactions in organic chemistry, let me down. Thanks!
PS: Some guesses on if and what solvent may be used in naphthalene lighter fluid.
EDIT:
It's actually Naphtha, sorry. Anything I can use THAT for? As a solvent?
Nathan
[Edited on 5-13-2014 by The Volatile Chemist]
[Edited on 5-13-2014 by The Volatile Chemist]
|
|
|
macckone
Dispenser of practical lab wisdom
Posts: 2168
Registered: 1-3-2013
Location: Over a mile high
Member Is Offline
Mood: Electrical
|
|
The first experiment that comes to mind is fractional distilling
and/or freezing to divide it into components and then determining
what each of those components is. For petroleum products this
is actually a high difficulty task.
|
|
|
deltaH
Dangerous source of unreferenced speculation
Posts: 1663
Registered: 30-9-2013
Location: South Africa
Member Is Offline
Mood: Heavily protonated
|
|
No, lighter fluid is not naphthalene (a solid used for moth balls), but usually a strongly hydrotreated light naphtha AFAIK... they are two different
things!
Lighter fluid is supposed to be very paraffinic (alkane hydrocarbons).
|
|
|
Zyklon-A
International Hazard
Posts: 1547
Registered: 26-11-2013
Member Is Offline
Mood: Fluorine radical
|
|
Yeah, I have a bottle of Zippo® lighter fluid. I have used it as a solvent for a few things before, but I mostly just use it to fill my
Zippo® lighters
Some general properties of Naphtha:
Fuel used in: Fire Eating, Fire Poi, Fire Hoop and Fire Buugeng.
Not recommended for: Fire Breathing
Flash Point: 44°C 2
Gravity: 0.75–0.785 g/cm3
Boiling Point: 160–220 °C (320–430 °F)
Vapor Pressure: Less than 5 torr (5 mm Hg).
Color: colorless (kerosene odor) or red-brown (aromatic odor) liquid
Solubility in Water: Insoluble
Naphtha is comprised of shorter chain hydrocarbons (c5-c7), can be aromatic (sweet smelling and carcinogenic), and can contain sulfuric compounds or
other impurities. It most often consists of paraffins with colorants and a thiol for scent. It has the lowest boiling point of all the petrols, which
gives it the highest vapor pressure. This means that it will produce flammable vapors whenever it’s not contained in a vapor-seal container, but
those vapors will disperse quickly if well ventilated.
|
|
|
The Volatile Chemist
International Hazard
Posts: 1981
Registered: 22-3-2014
Location: 'Stil' in the lab...
Member Is Offline
Mood: Copious
|
|
Quote: Originally posted by Zyklonb  | Yeah, I have a bottle of Zippo® lighter fluid. I have used it as a solvent for a few things before, but I mostly just use it to fill my
Zippo® lighters
Some general properties of Naphtha:
Fuel used in: Fire Eating, Fire Poi, Fire Hoop and Fire Buugeng.
Not recommended for: Fire Breathing
Flash Point: 44°C 2
Gravity: 0.75–0.785 g/cm3
Boiling Point: 160–220 °C (320–430 °F)
Vapor Pressure: Less than 5 torr (5 mm Hg).
Color: colorless (kerosene odor) or red-brown (aromatic odor) liquid
Solubility in Water: Insoluble
Naphtha is comprised of shorter chain hydrocarbons (c5-c7), can be aromatic (sweet smelling and carcinogenic), and can contain sulfuric compounds or
other impurities. It most often consists of paraffins with colorants and a thiol for scent. It has the lowest boiling point of all the petrols, which
gives it the highest vapor pressure. This means that it will produce flammable vapors whenever it’s not contained in a vapor-seal container, but
those vapors will disperse quickly if well ventilated. |
Thanks! Very Helpful. Do you happen to know what Kinds of compounds are or arent soluble in it? For example, I suppose most ionic compounds are
insoluble?
Thanks again!
Nathan.
|
|
|
Nicodem
|
Thread Moved
13-5-2014 at 10:39 |
chemrox
International Hazard
Posts: 2961
Registered: 18-1-2007
Location: UTM
Member Is Offline
Mood: LaGrangian
|
|
What an expensive solvent! It's a mixture of heavy and light hydrocarbons designed to burn when ignited but not spontaneously catch fire. Not very
good for cleaning as it would leave residual oils behind. I fractionated some fuels a few years back to get in practice. I found a wide variety. I
also found an almost continuous boiling range using a high reflux head and a longish Snyder column.
"When you let the dumbasses vote you end up with populism followed by autocracy and getting back is a bitch." Plato (sort of)
|
|
|
Zyklon-A
International Hazard
Posts: 1547
Registered: 26-11-2013
Member Is Offline
Mood: Fluorine radical
|
|
| Quote: Originally posted by The Volatile Chemist |
Thanks! Very Helpful. Do you happen to know what Kinds of compounds are or arent soluble in it? For example, I suppose most ionic compounds are
insoluble?
Thanks again!
Nathan. |
Your welcome.
No, I don't have any information of it's use as a solvent. Other than it's a nonpolar solvent so, yeah won't work well for ionic compounds.
|
|
|
alexleyenda
Hazard to Others
Posts: 277
Registered: 17-12-2013
Location: Québec, Canada
Member Is Offline
Mood: Busy studying chemistry at the University
|
|
In theory, as a solvent, because it is made of a diversity of hydrocarbons, it is not suitable at all for polar compounds (such as ionic compounds).
It could be suitable for non-polar compounds, However, the fact that it probably contains aromatic molecules which are much much more reactive than
simple alkanes normally used as solvent (ex: hexane/cyclohexane) makes it quite not really practical. You have to make sure no undesired reactions
that target aromatic molecules/alkenes/alkynes take place.
[Edited on 14-5-2014 by alexleyenda]
|
|
|
The Volatile Chemist
International Hazard
Posts: 1981
Registered: 22-3-2014
Location: 'Stil' in the lab...
Member Is Offline
Mood: Copious
|
|
Will it work for napalm (Gas + Styrofoam)? I never have access to gas, so this might be nice...
|
|
|
gdflp
Super Moderator
Posts: 1320
Registered: 14-2-2014
Location: NY, USA
Member Is Offline
Mood: Staring at code
|
|
Source for gas, parents car + siphon . Naptha might work for napalm, it has a
high octane rating so it might burn slightly faster, but both gasoline and naptha are nonpolar solvents so I'm going to lean towards yes.
|
|
|
Manifest
Script Kiddie Asshole
Posts: 229
Registered: 7-12-2012
Member Is Offline
Mood: No Mood
|
|
I don't understand the fascination with napalm, it burns, that's it? Can someone explain?
|
|
|
gdflp
Super Moderator
Posts: 1320
Registered: 14-2-2014
Location: NY, USA
Member Is Offline
Mood: Staring at code
|
|
It is a good demonstration of a colloidal suspension to a beginner, the fact that it burns just keeps them interested.
|
|
|
alexleyenda
Hazard to Others
Posts: 277
Registered: 17-12-2013
Location: Québec, Canada
Member Is Offline
Mood: Busy studying chemistry at the University
|
|
I guess the simple fact that it burns so easily, sticks and burns for quite a long time makes it unusual. And... Who doesn't like fire? :p Let's also
not forget that it has quite a reputation.
|
|
|
Zyklon-A
International Hazard
Posts: 1547
Registered: 26-11-2013
Member Is Offline
Mood: Fluorine radical
|
|
Do you live in a country that uses ethonal instead of gas (like somewhere in South America)? Or do your parents not let you use gas?
|
|
|
smaerd
International Hazard
Posts: 1262
Registered: 23-1-2010
Member Is Offline
Mood: hmm...
|
|
I agree with ChemRox distilling naptha can be pretty interesting to freshen up on fractional distillation. Snyder column though, very nice. Granted
there are more lively things to distill for the sake of distilling... However, I found in one of the lighter fluid brands that it had around 30%
(anecdote from memory) of low boiling 'petroleum ether'. That stuff is a pretty nice non-polar solvent. Not exactly buried treasure but hmmm, what
else can you do with a solvent?
|
|
|
subsecret
Hazard to Others
Posts: 424
Registered: 8-6-2013
Location: NW SC, USA
Member Is Offline
Mood: Human Sadness - Julian Casablancas & the Voidz
|
|
Perhaps you could crack the alkanes into things like ethylene...just pass the naptha vapors over hot fragments of porous porcelain or clay pot.
Collect over water. I know that this works with liquid paraffin (the same as our American kerosene, if I'm not mistaken), and I assume that it would
work with similar alkanes as well.
Fear is what you get when caution wasn't enough.
|
|
|
The Volatile Chemist
International Hazard
Posts: 1981
Registered: 22-3-2014
Location: 'Stil' in the lab...
Member Is Offline
Mood: Copious
|
|
Thanks for the suggestions everyone!
| Quote: Originally posted by Zyklonb |
Do you live in a country that uses ethonal instead of gas (like somewhere in South America)? Or do your parents not let you use gas?
|
No, I live in the mid-west US (Ohio to be exact), but the only gas we usually have on hand is in the car or for the lawn mower, so I'd rather not take
from them what they use all the time, and naphtha seemed even better, as it burns easier (I know, both are easy to ignite), I won't have to pay
anything for it, and my family isn't using it (No-one smokes anymore).
In regards to "Why Napalm?", first off it smells great in the morning. Second, it burns compactly and hot, but isn't too likely to explode (actually
it's explosiveness is just controllable). Teriderily, It sorta 'melts' as it burns, and burning, slowly flowing liquids look (and just are) cool. But
I've never made it, so I wondered if Naphtha would work. I'll probably only make 100mL of it, but it'll be a nice end-of-freshman-year fun.
|
|
|
aga
Forum Drunkard
Posts: 7030
Registered: 25-3-2014
Member Is Offline
|
|
C L A S S I F I E D
B O Z E Y E Y E S O N L Y
Napalm only sounds good/cool in English.
I visited Vietnam last December, and all the trees have grown back.
Agent White, thru Orange to Violet all got absorbed in the environment, and the Humans (as top of the food chain) concentrated the chemicals nicely.
Despite the multitude of deformities in newborn children, no side effects were seen.
EDIT: I'm English, so the Sarcasm may not immediately be apparent to North Americans.
[Edited on 15-5-2014 by aga]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
