Jermann
Harmless
Posts: 1
Registered: 17-9-2013
Member Is Offline
Mood: No Mood
|
|
RDX
Hello to all,
I wanted to ask the opinion of this synthesis. I have read a lot about "the preparatory manual of explosive second edition" but apparently does not
seem to be very reliable.
I studied in the school dedicated to winemaking and I know a little bit chemistry
Why in the second part of this synthesis using a dilute acid to 70% with sodium nitrite? The temperature does not seem too high? Doing so is not
dangerous and will ruin the performance?
reaction times are not too long?
Thanks in advance (sorry for my english).
Jermann
Place 220 grams of 99% nitric acid into a beaker, and then cool to 10 Celsius by means of a cold water bath. When the temperature of the 99% nitric
acid reaches about 10 Celsius, slowly add 20 grams of hexamine while stirring the 99% nitric acid and maintaining its temperature at about 10 Celsius.
After the addition of the hexamine, maintain the reaction mixtures temperature at 20 Celsius for 40 minutes with constant stirring. Then place 14
grams of 70% nitric acid and 2 grams of sodium nitrite into a flask and heat to 70 Celsius. When the temperature reaches 70 Celsius, slowly add the
reaction mixture while maintaining the temperature of the 70% nitric acid mixture at 70 Celsius and stirring. After the addition of the reaction
mixture, continue heating at 70 Celsius for about 40 minutes. After which, remove the heat source, and allow the reaction mixture to cool to room
temperature. Then place the reaction mixture into an ice bath, and cool to about 5 Celsius. Finally, add the entire reaction mixture to 500
milliliters of cold water and then filter-off the precipitated RDX product, wash with 200 milliliters of water, and then vacuum dry or air-dry.
|
|
|
AndersHoveland
Hazard to Other Members, due to repeated speculation and posting of untested highly dangerous procedures!
Posts: 1986
Registered: 2-3-2011
Member Is Offline
Mood: No Mood
|
|
It is to make nitrous acid in solution. The temperature needs to be lower both to keep the nitrous acid dissolved in solution, otherwise it will
escape as nitric oxide gases, and to prevent runaway reaction.
It seems that the hexamine is being nitrosated to Hexahydro-1,3,5-trinitroso-1,3,5-triazine (so-called 'R-salt'), which happens quite readily, and
this is then is hydrolyzed to the nitramine.
http://www.sciencemadness.org/talk/viewthread.php?tid=17706
[Edited on 17-9-2013 by AndersHoveland]
|
|
|
caterpillar
Hazard to Others
Posts: 472
Registered: 8-1-2012
Member Is Offline
Mood: No Mood
|
|
Purpose of 70% HNO3 + some nitrite is oxidization of linear and unstable nitramines. During this process temperature will go up and toxic gases (NO2
and CH2O) will be generated. I lost the great part of my RDX - temperature went up and reaction vessel (not a special one) cracked down. But I got
some crystals of RDX, not a dust. Only few grams, but I tested them with hammer. Sound was loud. They fired with hissing sound. Anders, you are not
right- when you add reaction mix to 70% HNO3, there is no hexamine at all. And no R-salt too.
Women are more perilous sometimes, than any hi explosive.
|
|
|
golfpro
Banned
Posts: 179
Registered: 18-5-2013
Member Is Offline
Mood: Cap Sensitive
|
|
What is the second 70%Nitric acid and sodium nitrite thing for???
Does this improve yield?
[Edited on 18-9-2013 by golfpro]
|
|
|
Pulverulescent
National Hazard
Posts: 793
Registered: 31-1-2008
Member Is Offline
Mood: Torn between two monikers ─ "hissingnoise" and the present incarnation!
|
|
| Quote: | What is the second 70%Nitric acid and sodium nitrite thing for???
Does this improve yield? |
It's bollocks! What you'd expect from Ledgard?
The nitrolysis calls for strong HNO3 and hexamine!
"I know not with what weapons World War III will be fought, but World War IV will be fought with sticks and stones"
A Einstein
|
|
|
caterpillar
Hazard to Others
Posts: 472
Registered: 8-1-2012
Member Is Offline
Mood: No Mood
|
|
Negative. You may simple put conc HNO3 with dissolved hexamine into water You'll get white dust of RDX + some impurities- linear nitramines. If you
want to get larger crystals, you may use simple water. Or small amount of 70% HNO3 + KNO2 (NaNO2). Nitrites here only to initiate oxidization
(oxidation? I do not know perfect word). After oxidization has been initiated, reaction mix generates enough nitric acid. So what you really need:
assume you have 70 gr of HNO3 + dissolved hexamine. You need the second vessel and into this vessel you have to put simultaneously dropwise this HNO3
and 30 gr of water with small amount of nitrite. Reaction will begin (if not, heat this vessel) and temperature will go up. Finally you'll get large
crystals of RDX. This procedure is described in russian book , written by Orlova. So you can do it without 70% nitric acid at all.
Women are more perilous sometimes, than any hi explosive.
|
|
|
Pulverulescent
National Hazard
Posts: 793
Registered: 31-1-2008
Member Is Offline
Mood: Torn between two monikers ─ "hissingnoise" and the present incarnation!
|
|
What are you on about?
"I know not with what weapons World War III will be fought, but World War IV will be fought with sticks and stones"
A Einstein
|
|
|
Motherload
Hazard to Others
Posts: 245
Registered: 12-8-2012
Location: Sewer
Member Is Offline
Mood: Shitty
|
|
Can the crude RDX obtained from standard nitrolysis be purified by standard Re-crystalization ??
If yes .... What is the purpose of the second step and waste more reagents ?
"Chance favours the prepared mind"
"Fuck It !! We'll do it live !!"
|
|
|
caterpillar
Hazard to Others
Posts: 472
Registered: 8-1-2012
Member Is Offline
Mood: No Mood
|
|
As I told you, you may perform oxidization without additional nitric acid. Therefore, there will be no wasting of useful reagents. Probably, this is
the best way to get rid of impurities, which make RDX unstable. After this op you'll have diluted HNO3- but you may use it for preparation of hexamine
dinitrate. Preparation of RDX from hexamine dinitrate has some advantages- it requires smaller amount of conc HNO3 and does not require WFNA- small
amount of NO2, presenting in HNO3 after distillation, may cause problems, if you use hexamine. I made RDX, using dinitrate.
Women are more perilous sometimes, than any hi explosive.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
