Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Help! thermometer mercury separated
beastmaster
Harmless
*




Posts: 38
Registered: 28-5-2008
Location: USA
Member Is Offline

Mood: hyper

[*] posted on 19-6-2011 at 23:24
Help! thermometer mercury separated


My last thermometer is defective because the mercury(or Alc.)separated, with some in the tip and most down where it belongs. I tryed shaking it out and heating it, but nothen works so far. I seem to remember a method to fix this but can't remember what or how its done. Any advice would be helpful. Thanks.
View user's profile View All Posts By User
Arthur Dent
National Hazard
****




Posts: 553
Registered: 22-10-2010
Member Is Offline

Mood: entropic

[*] posted on 20-6-2011 at 03:55


How far does your thermometer goes, I mean what's the lowest temperature it can read?

Try to get a hold of dry ice and a bit of acetone, put both in a small beaker and dip the bulb of your thermometer in it. If all goes well, all of the mercury should go all the way down to the bulb and when you bring it back to room temperature, there shouldn't be any separation in your mercury thermometer's capillary.

Robert




--- Art is making something out of nothing and selling it. - Frank Zappa ---
View user's profile View All Posts By User
ScienceSquirrel
International Hazard
*****




Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline

Mood: Dogs are pets but cats are little furry humans with four feet and self determination! :(

[*] posted on 20-6-2011 at 04:39


You can do it by holding the thermometer by the bulb end and tapping the top gently on the palm of your hand.
The alcohol will break up in to tiny droplets and fall back on to the column.
View user's profile View All Posts By User
The WiZard is In
International Hazard
*****




Posts: 1617
Registered: 3-4-2010
Member Is Offline

Mood: No Mood

[*] posted on 20-6-2011 at 06:45


Quote: Originally posted by beastmaster  
My last thermometer is defective because the mercury(or Alc.)separated, with some in the tip and most down where it belongs. I tryed shaking it out and heating it, but nothen works so far. I seem to remember a method to fix this but can't remember what or how its done. Any advice would be helpful. Thanks.

Try putting it in your freezer.


djh
----
The Dark Side of Amateur Experimentalism

New version of OxyContin
New York Times 16vi11

Though many addicts appear frustrated by
the reformulation ….. an addiction
medicine specialist…. Said that people
would figure out how to abuse the new
OxyContin.

“I like to think of them as drug addicts
in white lab coats,” he said….

[Recovering addict] …. It was possible
to snort the new OxyContin but it took
an about an hour to break it down.

“It’s like doing a science project,” he said,
“sitting there with a scraper, a knife, a
razor blade, like it’s a frog or something.”





View user's profile View All Posts By User
PHILOU Zrealone
International Hazard
*****




Posts: 2893
Registered: 20-5-2002
Location: Brussel
Member Is Offline

Mood: Bis-diazo-dinitro-hydroquinonic

[*] posted on 20-6-2011 at 09:38


Or maybe the other way arround...go to full scale high temp and then slowly cool down.
Don't go too high over the maximum temp because your thermometer may explode.




PH Z (PHILOU Zrealone)

"Physic is all what never works; Chemistry is all what stinks and explodes!"-"Life that deadly disease, sexually transmitted."(W.Allen)
View user's profile View All Posts By User

  Go To Top