Sulaiman
International Hazard
Posts: 3694
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
Vacuum valve suggestions required
To prepare for my long awaited (and probably one more year) new home lab
I want to convert my diy lash-up manometer/barometer
into a finished product.
My lash-up is basically two 1.5m long borosilicate tubes, 9.2mm I'd.
My entire stock of mercury (c73ml) fills about 1m of the tubing.
The rest is plastic tubing.
For use as a barometer I could seal one end of the U tube
but that would prevent use as a manometer.
So I use my dual-stage rotary to approximate absolute vacuum.
I want a valve on the manometer that can maintain less tham 1mm Hg vacuum for as long as cost-effective, ideally for months, hours would probably be a
minimum requirement.
[Edited on 30-1-2024 by Sulaiman]
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
Twospoons
International Hazard
Posts: 1324
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
Needle valves are commonly used for gas and vacuum work. Aliexpress is full of them (at modest prices), but if you want something guaranteed to work
try your local pneumatics supplier.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
