highpower48
Hazard to Self
Posts: 98
Registered: 30-10-2014
Member Is Offline
Mood: No Mood
|
|
Ammonium Acetate, what went wrong
Made some ammonium acetate by naturalizing 10% ammonia with white vinegar. Boiled from 1000ml to around 50ml it turned a golden brown. It's been
sitting in a beaker to finish evaporating but shows no sign of crystallization. For such a simple reaction, what went wrong?
|
|
njl
National Hazard
Posts: 609
Registered: 26-11-2019
Location: under the sycamore tree
Member Is Offline
Mood: ambivalent
|
|
Ammonium acetate is notoriously difficult to dry (deliquescent even) and I expect you will have to continue to heat it to get it out. The brown color
is probably from an impurity in the vinegar either becoming more concentrated or decomposing, although it could be the product decomposing. Another
way would be to add acetone and cool the solution as low as possible.
Reflux condenser?? I barely know her!
|
|
Amos
International Hazard
Posts: 1406
Registered: 25-3-2014
Location: Yes
Member Is Offline
Mood: No
|
|
A lot of people are under the impression that white vinegar is just acetic acid and water, but it also contains all sorts of yeast waste products. The
golden brown color is perfectly normal, so no worries. You’ve got ammonium acetate, just try boiling it down to a more syrupy consistency and then
chill it. It’s 5 times more soluble at 80C than at 0C, so do this correctly and you should get a massive crop of crystals.
|
|
S.C. Wack
bibliomaster
Posts: 2419
Registered: 7-5-2004
Location: Cornworld, Central USA
Member Is Offline
Mood: Enhanced
|
|
It would surprise me if any solid can ever be obtained by boiling off water from pure solutions of ammonia and the acid...the pH of such a distillate
could be interesting to follow.
|
|
Fyndium
International Hazard
Posts: 1192
Registered: 12-7-2020
Location: Not in USA
Member Is Offline
|
|
Some vinegar products contain only diluted acetic acid, while some contain a significant residue. I've faced both.
Ammonium acetate and ammonium formate cannot be effectively dried simply by boiling. They need to be vacuum distilled with high vacuum and low heat to
prevent decomposition, and/or dried finally with vacuum desiccator. Heating too much will decompose them to acetamide and formamide.
One method is to bubble ammonia gas into pure acetic or formic acid, with inverted funnel and very effective cooling and stirring, because the
reaction will generate enough heat to evaporate the acid. It will form a solid sludge, and it could possibly be diluted with anhydrous inert solvent
to keep them workable, and evaporating the solvent to obtain powder form. If the intended use does not warrant anhydrous reagent, it can be used wet,
just determining the approximate content, or as a limiting reagent in excess.
|
|