cokezero
Harmless
Posts: 11
Registered: 22-12-2010
Member Is Offline
Mood: No Mood
|
|
Copper Sulfate + Acetone
I have a solution of copper sulfate dissolved in water.
I would prefer to have the copper sulfate as crystals rather than a solution.
To a small amount of the solution I added Acetone.
When an amount of acetone that is slighty greater than the originally liquid is added to the solution and stirred blue crystals fall out of the
solution, and the liquid becomes colourless.
The question I have, is there by any chance a reaction happening between the copper sulfate and acetone ?
(I tend to think not, but thought I should check before doing this to the entire bottle.)
Thanks
P.S The blue crystals that do fall out of the solution once allowed to air dry for 10 minutes will have happliy dissolve back in to water, to form a
blue solution.
|
|
|
hkparker
National Hazard
Posts: 601
Registered: 15-10-2010
Location: California, United States
Member Is Offline
Mood: No Mood
|
|
The acetone is dissolving in water. When that happens it sounds like it is causing the copper sulfate to precipitate as it pulls the water off the
dissolved copper sulfate.
My YouTube Channel
"Nothing is too wonderful to be true if it be consistent with the laws of nature." -Michael Faraday
|
|
|
cokezero
Harmless
Posts: 11
Registered: 22-12-2010
Member Is Offline
Mood: No Mood
|
|
Yes, that is what I thought would be occuring.
Thanks for your thoughts
|
|
|
hkparker
National Hazard
Posts: 601
Registered: 15-10-2010
Location: California, United States
Member Is Offline
Mood: No Mood
|
|
Does the color of the blue change afterwards. I doubt it, but its possible the copper sulfate reacts with acetone to make copper acetate and sulfuric
acid. But if the dry crystals are the same color before and after that's not what's happening. Copper acetate is a much lighter blue.
My YouTube Channel
"Nothing is too wonderful to be true if it be consistent with the laws of nature." -Michael Faraday
|
|
|
cokezero
Harmless
Posts: 11
Registered: 22-12-2010
Member Is Offline
Mood: No Mood
|
|
I could check the ph of the colourless solution if sulfuric acid was being produced???
It could be a lighter colour, I am not the best with colours =/
|
|
|
unionised
International Hazard
Posts: 5126
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by hkparker  | | Does the color of the blue change afterwards. I doubt it, but its possible the copper sulfate reacts with acetone to make copper acetate and sulfuric
acid. But if the dry crystals are the same color before and after that's not what's happening. Copper acetate is a much lighter blue.
|
Acetone - acetate?
Where does the other carbon atom go?
|
|
|
bbartlog
International Hazard
Posts: 1139
Registered: 27-8-2009
Location: Unmoored in time
Member Is Offline
Mood: No Mood
|
|
Copper sulfate is slightly acidic and if it actually dissolved in the acetone, I would expect that leaving it to stand for a few weeks might result in
some condensation products. But, first of all, it doesn't sound like it's soluble; and second of all, such a reaction should take a long time at RT
(takes days even with HCl).
|
|
|
bfesser
Resident Wikipedian
Posts: 2114
Registered: 29-1-2008
Member Is Offline
Mood: No Mood
|
|
Just boil the aqueous CuSO4 down until you get crystals. It's easier and you'll get a higher purity product.
|
|
|
peach
Bon Vivant
Posts: 1428
Registered: 14-11-2008
Member Is Offline
Mood: No Mood
|
|
If you're after bigger crystals, you can let the water evaporate off slowly at room temperature. While you're at it with the copper sulphate, have a
practice at filtering and recrystallising it, see how clean you can get the result.
These need that doing to them.
Can YOU spot the crystals? 
These have been sat up there for months, but they'll be forming in days to weeks if left on the boiler, depends how much spare water you're
starting with. This is the rare and reclusive 'chemistria mushroomius'. I put a filter paper over the top to keep the brick and plasterboard dust
out.
I was growing these for a bit of fun. I remembered my inogranics teacher having a foot wide crystal of something in the lab, which he'd been
dunking for years and years, and thought..... that'd be neat to have. He must have got a big bag of the salt from somewhere for free. I think the
copper for these came from the wire in a guitar lead. It's best to use slightly too little sulphuric so you end up with a few bits of copper left in
there, then pick / filter them out. Sulphuric won't evaporate off unless you bake it off over 300C, which is not all that fun - the kitchen oven won't
get hot enough, you'd rot the jesus out of it did and there'll be plumes of sulphuric floating around in the air.
[Edited on 16-1-2011 by peach]
|
|
|
bquirky
Hazard to Others
Posts: 316
Registered: 22-10-2008
Location: Perth Western Australia
Member Is Offline
Mood: No Mood
|
|
I love your lego Mill !!
|
|
|
The WiZard is In
International Hazard
Posts: 1617
Registered: 3-4-2010
Member Is Offline
Mood: No Mood
|
|
| Quote: Originally posted by peach | | If you're after bigger crystals, you can let the water evaporate off slowly at room temperature. While you're at it with the copper sulphate, have a
practice at filter and recrystallising it, see how clean you can get them. |
You can buy copper sulphate in a plumbing or home (Lowies/Home
Depot perhaps) as Root killer.
I recommend —
Holden and Singer
Crystals and Crystal Growing
Anchor Books 1960
You can find used copies for US $1.00 +postage.
|
|
|
peach
Bon Vivant
Posts: 1428
Registered: 14-11-2008
Member Is Offline
Mood: No Mood
|
|
Mark 1 of the Legionia ball milling facility went into forced closure after OSHA received scandalous complaints regarding gross failures in the plants
health and safety standards, not limited to; hazardous connection to the grid, off permit dumping of toxic materials & routine physical abuse of
the staff.
The core of the mill is a glass medicine bottle loaded with glass marbles. The cap can be lined with PTFE.
| Quote: Originally posted by The WiZard is In |
You can buy copper sulphate in a plumbing or home (Lowies/Home
Depot perhaps) as Root killer.
I recommend —
Holden and Singer
Crystals and Crystal Growing
Anchor Books 1960
|
I'm not sure how easily available that would be now in the UK (off the shelf) without things added to it. They seem to be removing most of the raw
chemicals from the shelves, or adding things to them that will make it difficult to yield pure material.
I'm also kinked enough to occasionally enjoy the pleasure of struggling a little for things. It's very satisfying to have memories come back when
picking up a bottle of something.
Anyhoo, there's big bags of the stuff on eBay here, I simply felt like making my own at the time.
I will have to start having a look at crystal growing. I've spent a lot of time learning about semiconductor crystal work (having chats with staff
about molecular beam epitaxy and quantum devices), but my only at home attempts at crystal decoration have been those crystal trees kids you get as a
kid.
Which don't work.
Much akin to the 'grow your own mushroom' boxes you can get at the superstores, that yield five fairly normal mushrooms and a box of dirt at a tenner
a go.
[Edited on 16-1-2011 by peach]
|
|
|
cokezero
Harmless
Posts: 11
Registered: 22-12-2010
Member Is Offline
Mood: No Mood
|
|
| Quote: | | Copper sulfate is slightly acidic and if it actually dissolved in the acetone, I would expect that leaving it to stand for a few weeks might result in
some condensation products. But, first of all, it doesn't sound like it's soluble; and second of all, such a reaction should take a long time at RT
(takes days even with HCl). |
So it is probably unlikely in the space of ten minutes the copper sulfate is is reacting with the acetone.
| Quote: | | Just boil the aqueous CuSO4 down until you get crystals. It's easier and you'll get a higher purity product. |
Yes, that is option although it does take somewhat longer.
|
|
|
smaerd
International Hazard
Posts: 1262
Registered: 23-1-2010
Member Is Offline
Mood: hmm...
|
|
CuSO4 is also available at pottery stores in a fairly good purity  .
|
|
|
hkparker
National Hazard
Posts: 601
Registered: 15-10-2010
Location: California, United States
Member Is Offline
Mood: No Mood
|
|
I got mine as root killer from ace and it was great
My YouTube Channel
"Nothing is too wonderful to be true if it be consistent with the laws of nature." -Michael Faraday
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination! 
|
|
Good quality copper sulphate is readily available off eBay and elsewhere in the UK.
It is used for all sort of things like home made organic fungicides.
It is not very toxic, not of much use in making improvised explosives or anything illegal, so I would guess that it will remain readily available in
the future.
|
|
|
cokezero
Harmless
Posts: 11
Registered: 22-12-2010
Member Is Offline
Mood: No Mood
|
|
It is not a problem to buy.
The question I have is when you add acetone to a copper sulfate solution, the crystals that fall out of the solution are they still copper sulfate or
has a chemical reaction occured between the acetone and copper sulfate converting the copper sulfate to something else?
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination!
|
|
It is almost certainly a copper sulphate hydrate salting out.
Probably the pentahydrate with some occluded acetone / water.
It depends on concentration and temperature on the exact hydrate formed but I would bet on a hydrate as water is a lot stronger Lewis basis than
acetone.
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination!
|
|
Cleavage of the acetone is unlikely.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
