Pages:
1
2
3 |
G-Coupled
Hazard to Others
Posts: 287
Registered: 9-3-2017
Member Is Offline
Mood: Slightly triturated
|
|
For USD160 for a 5L stirrer/mantle down to USD60 for a 500ml one, yes - I am (or hopefully will be) so into them.
If they're just OK as is, or can be easily tweaked to work safely and well, then at these prices, IMO they could be nothing short of revolutionary for
affordable home chemistry.
|
|
vibbzlab
Hazard to Others
Posts: 241
Registered: 6-11-2019
Member Is Offline
Mood: Always curious
|
|
If that mantle has a stirrer I would have definitely bought it.
Amateur chemist. Doctor by profession
Have a small cute home chemistry lab.
Please do check out my lab in YouTube link below
This is my YouTube channel
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
Again is that bexco mantle regulated with a Variac in that boxy part where the dial is?why is there a rectangle attached to the mantle when a circuit
board will do.
|
|
vibbzlab
Hazard to Others
Posts: 241
Registered: 6-11-2019
Member Is Offline
Mood: Always curious
|
|
That's just hollow . It has nothing in it. Waste of space
Amateur chemist. Doctor by profession
Have a small cute home chemistry lab.
Please do check out my lab in YouTube link below
This is my YouTube channel
|
|
Sulaiman
International Hazard
Posts: 3697
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
I do not know, but I suspect that there is a simple bi-metalic switch mechanism in that box,
the size of the box may be arbitray, or to insulate the switch from the heat of the mantle,
at those prices an inbuilt variac is very unlikely.
The good news is that you have plenty of space to replace the (presumed) bi-metalic controller with a cheap eBay triac based 'dimmer' module.
(I really like those modules - fine control of constant power)
The only difficult part for a non experienced electrician may be a little re-wiring.
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
vibbzlab
Hazard to Others
Posts: 241
Registered: 6-11-2019
Member Is Offline
Mood: Always curious
|
|
Take care not to die of electrocution. That stuff is really dangerous
Amateur chemist. Doctor by profession
Have a small cute home chemistry lab.
Please do check out my lab in YouTube link below
This is my YouTube channel
|
|
RogueRose
International Hazard
Posts: 1594
Registered: 16-6-2014
Member Is Offline
|
|
IDK if you have ever tried something like a router speed control or a dimmer but I think those should work well for a heat gun as it's a normal
resistive load - nichrome. The controllers are basically triac controllers and I know most can do 1500w or more. I use mine on a vacuum cleaner
(universal motor - brushed AC) and it works great at controlling how much suction or "blowing" (lol) I get and it the motor doesn't seem to mind even
hours on end.
I know the 2000w triac "motor controllers" on ebay ($4-10) also list uses as heater controller, which is also a plain resistive load. I'm guessing
that is what is in my more expensive "Master Appliance" heat gun (750w only) and it has a little triac control for only the element, so it should be
good.
|
|
vibbzlab
Hazard to Others
Posts: 241
Registered: 6-11-2019
Member Is Offline
Mood: Always curious
|
|
What do you guys think on butane torch
Amateur chemist. Doctor by profession
Have a small cute home chemistry lab.
Please do check out my lab in YouTube link below
This is my YouTube channel
|
|
G-Coupled
Hazard to Others
Posts: 287
Registered: 9-3-2017
Member Is Offline
Mood: Slightly triturated
|
|
Clean when hot and blue - IDK about how clean they are running cooler with a more yellow flame. Open flame, though.
If open flames don't bother you, then a lot of early experimenters used little Methanol burners that worked well enough. Should be cheap as chips to
buy and to run.
|
|
vibbzlab
Hazard to Others
Posts: 241
Registered: 6-11-2019
Member Is Offline
Mood: Always curious
|
|
I do use Alcohol burner now
Amateur chemist. Doctor by profession
Have a small cute home chemistry lab.
Please do check out my lab in YouTube link below
This is my YouTube channel
|
|
Pages:
1
2
3 |