Germanys_Finest
Harmless
Posts: 4
Registered: 14-11-2006
Member Is Offline
Mood: No Mood
|
|
Novel way to produce HF-NaF?
I have a can of dust-off (difluoroethane) and the decompostion product is HF. I will be setting up a boiling flask with 1 hole rubber stopper with
tubing leading into an erlenmeyer flask with dh2o and strong magnetic stirring to capture the HF vapors.
The question is at what temp. does difluoroethane decompose?
Really my purpose is to produce NaF so should I just bubble this HF gas through a NaOH sol. or produce aq. HF first then react the 2 compounds?
Thanks in advance!
|
|
Jdurg
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 220
Registered: 10-6-2006
Location: Connecticut, USA
Member Is Offline
Mood: No Mood
|
|
Bubble through a concentrated NaOH solution. HF eats glass like it's candy. By bubbling HF into your erlenmeyer flask, you will destroy your flask.
There is no doubt about that. You would be best off doing this in a plastic container. In addition, make sure that you have plenty of calcium
gluconate gel around in case you get any HF on your skin. It's fairly nasty if you're not careful with what you are doing.
\"A real fart is beefy, has a density greater than or equal to the air surrounding it, consists of the unmistakable scent of broccoli, and usually
requires wiping afterwards.\"
http://maddox.xmission.com.
|
|
Twospoons
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1314
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
Well, it definitely decomposes on ignition! My workmate and I used to send fireballs at each other using freeze spray cans - until, after choking on
the fumes, I read the can and realised we were lighting an HFC - and the choking gas probably contained HF
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
I think you might do better passing the gas over hot NaOH or Na2CO3. That way you don't have to deal with HF.
|
|
Chris The Great
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 463
Registered: 29-10-2004
Location: Canada
Member Is Offline
Mood: No Mood
|
|
Would the gas react directly with NaOH to give NaF and various unwanted organic compounds? If so that would be the easiest method, just spray the gas
into a hot solution of NaOH or solid NaOH if that is needed.
|
|