Pages:
1
2 |
Conure
Harmless
Posts: 46
Registered: 6-2-2023
Location: Schweden
Member Is Offline
|
|
I had a bump yesterday when trying to evaporate my first solution of NH4NO3! I got scared!
Fire is good. Fire is life.
|
|
fx-991ex
Hazard to Self
Posts: 97
Registered: 20-5-2023
Member Is Offline
|
|
For NH4NO3 i drive most water out on hotplate with stirring then when almost all the water is out(usually temp start rising), i just set the hotplate
to keep the sln at around 90-95C with a fan blowing on it.
It take a few hours but i get a very dry product this way.(i usually do that in the cold canadian winter, when humidity is very low.)
Its best to manually mix it once in a while on the last stage, dont want a solid cake at the bottom of beaker that you cant take out and have to
redissolve.
Or use evaporating dish.
[Edited on 26-7-2024 by fx-991ex]
|
|
Deathunter88
National Hazard
Posts: 518
Registered: 20-2-2015
Location: Beijing, China
Member Is Offline
Mood: No Mood
|
|
Lots of terrible advice being thrown around this thread, I must say. You should never intentionally scratch your glassware just to avoid bumping, you
are just asking for your glassware to break (ever looked into how glass is "cut", you score the glass and then it breaks like crackers). In fact, my
lab throws away any beaker or flask that is scratched.
No matter if a measuing cup is made of borosilicate or soda lime, it should never be heated on the stove because the shape is not made to handle the
thermal stress and the glass itself is too thick to expand evenly.
Finally, using any old broken ceramic or glass for boiling chips is also not recommended, since they themselves can scratch the bottom of your
glassware leading to the same issues as mentioned before.
|
|
Pages:
1
2 |