coherent
Harmless
Posts: 19
Registered: 27-6-2023
Location: Australia
Member Is Offline
Mood: Curious
|
|
Addition funnel frustration
I've been having a very painful time getting consistent drop rates from my addition funnel, it has a glass stopcock and seems to be very prone to
freezing up but also it's extemely difficult to get it set to the desired rate.
Is there any trick to it? lubricant or similar to deal with the lockup and make the action of the stopcock more smooth?
|
|
Texium
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4547
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
Are you not greasing it?
|
|
coherent
Harmless
Posts: 19
Registered: 27-6-2023
Location: Australia
Member Is Offline
Mood: Curious
|
|
Sounds like that would be the problem, is silicone grease a suitable choice and are there limitations I should be aware of?
Cheers!
|
|
Texium
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4547
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
Silicone grease is fine. Don’t use too much, and try to avoid getting it into the hole in the stopcock. It’s impossible to avoid a little grease
contamination in your material whenever you use a greased glass stopcock though. Because of that I try to avoid glass ones whenever possible, and
greatly prefer the PTFE variety since they don’t freeze and don’t require grease.
|
|
Grizli7
Harmless
Posts: 40
Registered: 1-9-2021
Member Is Offline
|
|
or soak the crane for a funnel substance
|
|