mysteriusbhoice
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 477
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
OTC deep bed gravity microfiltration with minimal pressure drop
https://youtu.be/NXCHw21RGEo
The superabsorbent "scotch brite pad" allows for 2 actions to occur minimizing pressure drop when doing gravity microfiltration.
1. the superabsorbent nature pulls in the water and due to its shape it collects at the bottom thus dripping down thus allowing for great filtration
rate even if the filter gets clogged.
2. the effect of multiple layers leading to deep bed filtration also reduces pressure drop thus allowing for decent filtration rate.
This product overall allows you to gain access to a cheap way to perform microfiltration without spending a lot.
|
|
Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
I found that most decent quality N95 masks do a similar good job in filtration,they can also break emulsions.
|
|
VeritasC&E
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 176
Registered: 29-1-2018
Member Is Offline
Mood: No Mood
|
|
Do you know what they are made of? is it cellulose? or synthetic fibers? and it what conditions it may contaminate the solvent? They are fairly cheap
to get by. I've also wondered about the possibility of using those filters* used to take out microparticles in air (like in vacuum cleaners, or car
habitacle air circulation systems, or clean room / lab air filtration systems), but I always figured they probably wouldn't do well / be compatible
with solvents for some reason (feared they would be either hydrophobic or have too small pores or that they might be contaminating to the solvent; but
hey, fear is the enemy if progress!).
*HEPA Filters
[Edited on 26-7-2022 by VeritasC&E]
|
|
Texium
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4547
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
N95 masks are made of polypropylene fibers. Should be resistant to most chemicals.
|
|
VeritasC&E
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 176
Registered: 29-1-2018
Member Is Offline
Mood: No Mood
|
|
Thank you for the information! This may save some money in many situations. It also has a fairly large surface area so I guess they may allow for
reasonably fast filtration in relation to their small "pore size", plus they are probably more solid than most lab filters. Best used under 40C I
would guess.
|
|
Mateo_swe
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 526
Registered: 24-8-2019
Location: Within EU
Member Is Offline
|
|
I have seen many videos and post regarding cells, membranes and similar from you mysteriusbhoice.
Just wanted to let you know its always interesting and informative, keep the good work going, its appreciated.
|
|
Gammatron
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 125
Registered: 30-8-2022
Location: Abandoned Uranium Mines
Member Is Offline
|
|
I have found microfiber cloths to work exceptionally well for large volumes. Just stretch it over a bucket with clamps rather than using a funnel.
Filters extremely small particles at a decent rate, I use them for separating clay particles from solution when processing ores.
|
|
Texium
|
Thread Moved 30-11-2023 at 10:48 |