Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
Guanidine HCl to Guanidine Acetate
So I want to turn Guanidine.HCl into Guanidine Acetate for the usual nefarious purposes.
I tried Sodium Methoxide in Methanol and endet up with a flask full of milk, at least it looks like milk and nothing settles. My mistake, I should
have used Ethanol or IPA, I underestimated the solubility of NaCl in MeOH which causes the problem.
Added some Ether and in the freezer and I hope I will be able later to do some filtration.
Meanwhile I did some more reading up and it appears that Guanidne Base is kinda allergic against acids except very weak ones. It was suggested to
dilute the GAA to 0,1 N what would lead to pretty large volumes of solvent.
I will try with a higher concentration but as cold as possible (about - 20°C for me) and hope I don't trigger to much side reactions.
That's the situation now, but for the next time I want to do this different, I found out that Silver acetate or Thallium acetate in EtOH will do the
job and this would be the best method. I agree, just a small problem, my russian silver mines are at the moment unaccessible and I spent all my
Thallium on resolving some problems with obnoxious relatives (with good success btw.).
Any suggestions what other more common metal-acetates could be used? Why Silver and Thallium? All I fathom it is about solubility.
Would Sodium or Potassium Acetate in Ethanol or IPA not suffice, the almsot insoluble NaCl dropping out driving the methatesis to completion?
thx
/ORG
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Lead acetate solution would be the "classic" option, but a bit toxic.
As you surmised, it's about (aqueous) solubility. Lead acetate is soluble, lead chloride isn't.
An ion exchange resin column loaded with hydroxide would convert the guanidinium chloride to hydroxide which you could then titrate against acetic
acid.
|
|
Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
Lead? Still better then Thallium. Darn, I should have bought the big lump of lead on offer lately for cheap on Ebay-KAZ.
I am actually trying to keep this anhydrous for the followup reaction doesn't like water, also water introduces another plethora of possible but
undesired side-reactions. Those nitrogen compounds, guanidines and cyanamides seem all to be quite the snowflakes ![:o](./images/smilies/shocked.gif)
Thanks.
Gotta dig up some reasonable pure lead for next time and now see what I can save from the mess.
/ORG
Addon:
Quote: |
An ion exchange resin column loaded with hydroxide
|
You mean if I activate a new Britta waterfilter cartouche with NaOH solution it will turn guanidine.HCl into guanidine hydroxide when dissolved in
water and passing through this filter, maybe two or three times for completeness? Guanidine hydroxide just being what guanidine dissolved in water
naturally is?
Now thats an interesting one for sure, can I load the column with Ethoxide and run the guanidine.HCl in absolute alcohol through the filter and get
the anhydrous base this way?
[Edited on 17-9-2022 by Organikum]
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3026
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
At 25 degrees you can make a 1.6 M solution of potassium acetate in ethanol, which is 16 times more than the 0.1 N acetic acid they advice to use. I
would go for that. KCl only dissolves with 0.3 grams per liter. Also you don't have to make the freebase.
[Edited on 17-9-2022 by Tsjerk]
|
|
Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
Quote: Originally posted by Tsjerk ![](images/xpblue/lastpost.gif) | At 25 degrees you can make a 1.6 M solution of potassium acetate in ethanol, which is 16 times more than the 0.1 N acetic acid they advice to use. I
would go for that. KCl only dissolves with 0.3 grams per liter. Also you don't have to make the freebase.
[Edited on 17-9-2022 by Tsjerk] |
Won't sodium acetate be better, it only dissolves to 0,065g/l in Ethanol whats five times less then KCl? Solubility in Methanol is only 1,31g/l and it
makes already such a mess.
I wanted to give the sodium acetate a shot in a small experiment anyways.
thx
/ORG
[Edited on 17-9-2022 by Organikum]
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3026
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
Milk in methanol you say? Couldn't that be freebase guanidine freebase that doesn't dissolve in methanol that well? Even if it would be NaCl, wouldn't
you then want another salt to precipitate? Say KCl?
Sure sodium acetate could work, but with potassium acetate you need almost three times less solvent.
[Edited on 17-9-2022 by Tsjerk]
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by Organikum ![](images/xpblue/lastpost.gif) |
You mean if I activate a new Britta waterfilter cartouche with NaOH solution it will turn guanidine.HCl into guanidine hydroxide when dissolved in
water and passing through this filter, maybe two or three times for completeness?
[Edited on 17-9-2022 by Organikum] |
You would need to separate the two resins that are present in the filter or you would probably find that the guanidine bit stuck to the cation
exchanger.
And it would probably work better as a relatively long thin column than a typical water filter.
I don't think they work with non-aqueous systems.
it would be interesting to experiment.
|
|
Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
Quote: Originally posted by Tsjerk ![](images/xpblue/lastpost.gif) | Milk in methanol you say? Couldn't that be freebase guanidine freebase that doesn't dissolve in methanol that well? Even if it would be NaCl, wouldn't
you then want another salt to precipitate? Say KCl?
Sure sodium acetate could work, but with potassium acetate you need almost three times less solvent.
[Edited on 17-9-2022 by Tsjerk] |
Thanks for the very helpful suggestions!
I will actually reduce the solvent volume even more and add the salts, guanidine.HCl and sodium acetate in portions. The only thing I have to find out
is the solubility of guanidine acetate in EtOH, what I should be able to determine by experiment myself soon, my first try did not work as planned
but it is also not a complete writeoff and some guanidine acetate will be available.
And yes in methanol it will get like milk, the formed NaCl crystals are so tiny. I talked to some people and it seems I am not the first one to make
this experience.
Of course if somebody wants to create NaCl nano-particles - thats the way to go obviously.
regards
/ORG
|
|