Bmoore55
Hazard to Self
Posts: 85
Registered: 23-7-2018
Location: Texas
Member Is Offline
|
|
Para Nitrophenol Isolation-New Video
Hello all! I have just uploaded a new video on the isolation of Para-Nitrophenol to my youtube page. This is a follow up to the phenol nitration video
I previously did. Here I show how to isolate the para product from the remaining organic material in the distillation pot and then I analyzed the end
product. I also analyzed all the different waste fractions form this synthesis to show what is remaining in them using gas chromatography with mass
spectrometry (GCMS). I hope you all enjoy!
https://youtu.be/Q18jSxmcoSw
|
|
|
j_sum1
Administrator
Posts: 6335
Registered: 4-10-2014
Location: At home
Member Is Offline
Mood: Most of the ducks are in a row
|
|
Saved to my watch later. Looking forward to this one.
|
|
|
Keras
National Hazard
Posts: 936
Registered: 20-8-2018
Location: (48, 2)
Member Is Offline
|
|
I took only a perfunctory look at it, but I hardly see the point of the last ¾ of the video. I mean, the video is technically great, no doubts about
it. But it’s not really useful, given that 99.999% of us don’t have access to the analysis apparatuses you use.
If you want, I can parallel this with amateur radio: I can shoot a video showing how to tune whatever Yagi antenna using a 60k$+ network analyser I
have in the lab at work. But that wouldn't help no one, because either they are part of the 99.99999% of hams who don’t have access to such an
equipment, and the lucky 0.00001% left who have know how to use it. Instead, I can decide to show how to do it using a self-made SWR-meter, and that
would be much more useful. As a last step, I would confirm the usefulness of that method by using the expensive tool.
Now what I would've done is recrystallise the p-nitrophenol you got, check his purity with a TLC using a suitable solvent (semi-polar, probably), and
finally confirm the purity using GCMS. While I legit understand your curiosity as to what the tarry products are, I think most of us are just going to
dispose of them by whatever responsible means (last time I diluted them in ethanol and burnt the mix).
I don’t want to come across as rude or whatever. I think it’s very cool that you have access to high-performance analysis tools, and that you
could use it to vouch for the usefulness of a lot of elementary procedures the amateur chemist uses. After all, as someone else quoted on another
thread, chemists were able to identify and purify compounds well before the days of dear electronic equipment, but those can assess products with a
precision no other everyday manipulation could come close to.
[Edited on 11-5-2022 by Keras]
|
|
|
Fery
International Hazard
Posts: 1026
Registered: 27-8-2019
Location: Czechoslovakia
Member Is Offline
|
|
Bmoore55 well done and thanks for sharing your knowledge and skills! For me the video is very interesting. I did the synthesis and also the
challenging separation of isomers. In my experiment the para isomer oiled out during crystallization from 2% HCl so I had to repeatedly extract it
from the tarry mass reusing mother liquor and then crystallize from not too much hot solution as when the T and thus saturation was above some limit
the product always oiled out from the beginning and only later the desired crystals started to form. I was able to simply scrap the crystals and
mechanically separate them from the solidified tar at the bottom adhering to glass. Later I tried to purify the lowest quality crop by
recrystallization from 0,5% sodium bisulfite solution with pH=5,4-6,4 which removed the discoloration completely and produced white crystals.
https://www.sciencemadness.org/whisper/viewthread.php?tid=15...
|
|
|
Oxy
Hazard to Others
Posts: 140
Registered: 1-12-2020
Member Is Offline
|
|
Quote: Originally posted by Keras  | I took only a perfunctory look at it, but I hardly see the point of the last ¾ of the video. I mean, the video is technically great, no doubts about
it. But it’s not really useful, given that 99.999% of us don’t have access to the analysis apparatuses you use.
[Edited on 11-5-2022 by Keras] |
This is what makes Bmoore55's unique.
Well done Bmorre55!
[Edited on 12-5-2022 by Oxy]
|
|
|
Tsjerk
International Hazard
Posts: 3032
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
| Quote: Originally posted by Keras | I took only a perfunctory look at it, but I hardly see the point of the last ¾.
[Edited on 11-5-2022 by Keras] |
Who cares for knowledge right? I like watching YouTube videos because I can watch stuff I would never be able to do at home
[Edited on 11-5-2022 by Tsjerk]
|
|
|
Keras
National Hazard
Posts: 936
Registered: 20-8-2018
Location: (48, 2)
Member Is Offline
|
|
| Quote: Originally posted by Tsjerk |
Who cares for knowledge right? I like watching YouTube videos because I can watch stuff I would never be able to do at home
[Edited on 11-5-2022 by Tsjerk] |
Don’t get me wrong. The video is great. But it is a misnomer. It should’ve been called something like "Introduction to GCMS with an example:
p-nitrophenol" and that would've been perfectly fine with me. But advertised as it is r.n., I was expecting a lot more about p-nitrophenol
purification and analysis, and much less about anything else. Now, to each their own.
|
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
Excellent video. 10/10 plz keep making them as YouTube may have other videos on p,nitrophenol and on the analytical machines you use but they are
rather dry and boring by comparison, don't go into detail, or are just online content for University classes.
You mix both analysis and amateur experimenting well into high quality interesting content
[Edited on 12-5-2022 by draculic acid69]
|
|
|
Bmoore55
Hazard to Self
Posts: 85
Registered: 23-7-2018
Location: Texas
Member Is Offline
|
|
| Quote: Originally posted by Keras | | Quote: Originally posted by Tsjerk |
Who cares for knowledge right? I like watching YouTube videos because I can watch stuff I would never be able to do at home
[Edited on 11-5-2022 by Tsjerk] |
Don’t get me wrong. The video is great. But it is a misnomer. It should’ve been called something like "Introduction to GCMS with an example:
p-nitrophenol" and that would've been perfectly fine with me. But advertised as it is r.n., I was expecting a lot more about p-nitrophenol
purification and analysis, and much less about anything else. Now, to each their own. |
That is a perfectly fair critique. I don't expect all replies to be glowing praise and I see this as nothing but constructive criticism. Hopefully the
video was a little fun at times, that is all I am striving for is to be a little entertaining and informative. Hopefully you will still come back to
watch what I make in the future. Thanks again for the feedback!
|
|
|
Tsjerk
International Hazard
Posts: 3032
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
I think this video was very interesting because now at least I know a little bit more about where my yield is going.
|
|
|
Bmoore55
Hazard to Self
Posts: 85
Registered: 23-7-2018
Location: Texas
Member Is Offline
|
|
| Quote: Originally posted by Tsjerk | | I think this video was very interesting because now at least I know a little bit more about where my yield is going. |
That was partly what I was going for. For example when I watch an Explosions and Fire video and he jokes about low yield or the dreaded tar, well I
can look into those sorts of things and mane show if something is polymerizing, degrading, or if maybe the product has gone into a phase/fraction we
did not expect. I just thought a deep dive into the other stuff aside from just the end product would be interesting.
|
|
|
Fery
International Hazard
Posts: 1026
Registered: 27-8-2019
Location: Czechoslovakia
Member Is Offline
|
|
Low yield of para nitrophenol is due to its solubility in water as well in 2% HCl. From too much concentrated solution I observed always oiling out.
Crystals formed when ratio about 2 g in solution from which 1 g of crystals and 1 g stayed in mother liquor. You have to crystallize from not too much
hot and not too much concentrated solution. I improved yield by repeatedly reusing mother liquor but at the cost of purity.
|
|
|
Keras
National Hazard
Posts: 936
Registered: 20-8-2018
Location: (48, 2)
Member Is Offline
|
|
I’m still wondering why people keep insisting on nitration while nitrosation by nitrous acid generated in situ produces almost pure p-nitrosophenol.
Okay, I’m still groping in the dark for the proper recipe, despite everything written here and there, but if the goal is ultimately to get
p-aminophenol by reduction, then the p-nitrosophenol intermediate is likely to be much more interesting.
|
|
|
Fery
International Hazard
Posts: 1026
Registered: 27-8-2019
Location: Czechoslovakia
Member Is Offline
|
|
because by nitration you obtain also o-nitrophenol
|
|
|
Keras
National Hazard
Posts: 936
Registered: 20-8-2018
Location: (48, 2)
Member Is Offline
|
|
I totally agree if your goal is to get o-nitrophenol!
|
|
|
Texium
Administrator
Posts: 4619
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
| Quote: Originally posted by Bmoore55 | | Quote: Originally posted by Keras | | Quote: Originally posted by Tsjerk |
Who cares for knowledge right? I like watching YouTube videos because I can watch stuff I would never be able to do at home
[Edited on 11-5-2022 by Tsjerk] |
Don’t get me wrong. The video is great. But it is a misnomer. It should’ve been called something like "Introduction to GCMS with an example:
p-nitrophenol" and that would've been perfectly fine with me. But advertised as it is r.n., I was expecting a lot more about p-nitrophenol
purification and analysis, and much less about anything else. Now, to each their own. |
That is a perfectly fair critique. I don't expect all replies to be glowing praise and I see this as nothing but constructive criticism. Hopefully the
video was a little fun at times, that is all I am striving for is to be a little entertaining and informative. Hopefully you will still come back to
watch what I make in the future. Thanks again for the feedback! |
Can't win them all I guess. I watched it
last night and thought it was fantastic! I especially liked to see the analysis of the aqueous layers, because I always wonder how much material I'm
losing during workups. Cool to see the 2,4- and 2,6-dinitrophenols in the aqueous phase as well. Also, the 4-hydroxy-4-methyl-2-pentanone that you see
in a few of those runs is definitely from the acetone. It's the first product of acetone self-aldol condensation and is actually also known as
"diacetone alcohol."
I would suggest that you keep being yourself and doing what you're doing, as these first couple videos have been great. No need to force it to be more
"fun" just to pander to people who don't appreciate the content.
|
|
|
Keras
National Hazard
Posts: 936
Registered: 20-8-2018
Location: (48, 2)
Member Is Offline
|
|
| Quote: Originally posted by Texium |
| Quote: Originally posted by Bmoore55 |
That is a perfectly fair critique. I don't expect all replies to be glowing praise and I see this as nothing but constructive criticism. Hopefully the
video was a little fun at times, that is all I am striving for is to be a little entertaining and informative. Hopefully you will still come back to
watch what I make in the future. Thanks again for the feedback!
|
|
I will! It’s nice to see what a modern chemistry lab looks like and what you can do with the various devices there! I thought it was filmed in an
uni lab, but apparently this is all yours. I’m flabbergasted! :p Also please also do continue. There are not enough good chemistry videos out there,
so every new one is warmly welcome, especially when they’re technically outstanding!
| Quote: Originally posted by Texium |
I would suggest that you keep being yourself and doing what you're doing, as these first couple videos have been great. No need to force it to be more
"fun" just to pander to people who don't appreciate the content. |
I strongly agree with that. Try to not fall into the same trap as NileRed, for example. Sounds like his channel has become a dog and pony show, and
that’s a shame.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
