alchemizt
Harmless
Posts: 36
Registered: 28-1-2019
Member Is Offline
|
|
What happens when you mix hexane, water and chloroform?
I want to try this but haven't got around to it yet. I suspect adding chloroform first, pouring water on top, then hexane on top of the water will
form 3 layers. What happens if you then shake the vessel?
|
|
DraconicAcid
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4299
Registered: 1-2-2013
Location: The tiniest college campus ever....
Member Is Offline
Mood: Semi-victorious.
|
|
Before you shake it, you'll have three layers. After you shake it, you'll have two layers- which one is on top will depend on the ratio of hexane to
chloroform you use.
Please remember: "Filtrate" is not a verb.
Write up your lab reports the way your instructor wants them, not the way your ex-instructor wants them.
|
|
Texium
|
Thread Moved 17-3-2022 at 06:09 |
Texium
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4547
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
Unless your hexanes/chloroform layer has a density almost identical to your water layer, in which case you'll end up with a cloudy emulsion that
doesn't want to separate on an agreeable timescale.
|
|
alchemizt
Harmless
Posts: 36
Registered: 28-1-2019
Member Is Offline
|
|
Quote: Originally posted by DraconicAcid ![](images/xpblue/lastpost.gif) | Before you shake it, you'll have three layers. After you shake it, you'll have two layers- which one is on top will depend on the ratio of hexane to
chloroform you use. |
In acid base extractions, I have seen many times that 3 layers form and no matter how much I shake it and mix it, the 3 layers just reform themselves.
I've never tried this with pure water, does it work differently? If the two organic layers mix into one, can you separate them again by adding salt?
[Edited on 24-3-2022 by alchemizt]
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3026
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
What you are seeing is a base that is not that soluble in the apolar solvent. When this happens you will see three layers, usually a bottom water
layer, a middle base layer and a top apolar layer. Although I have also seen it when using DCM, where the lower layer was the apolar one.
You can prevent this by using a more or less polar solvent, to better match the base to be extracted, or just more solvent.
[Edited on 24-3-2022 by Tsjerk]
|
|