rsgpit
Harmless
Posts: 14
Registered: 19-5-2006
Member Is Offline
Mood: No Mood
|
|
Considered LE or HE?
The stoichiometric mix of hydrogen/oxygen reacts at 8160fps. I know ANFO is considered HE and detonates at 4000mps. Hydroxy is about half that speed.
Anyone know what it is considered.
Whatever it is though, gallon baloons make a hell of a bang.
|
|
|
Chris The Great
Hazard to Others
Posts: 463
Registered: 29-10-2004
Location: Canada
Member Is Offline
Mood: No Mood
|
|
H2 and O2 can move from burning into detonation if yo have enough. Same with acetylene. Nearly every gas/air mixture will do this but H2/O2 does it
exceptionally easily, the same with acetylene. Your balloons are probably big enough for the pure O2/H2 to detonate, H2 and air needs over a 1m
diameter before it begins to move into detonation.
|
|
|
Axt
National Hazard
Posts: 818
Registered: 28-1-2003
Member Is Offline
Mood: No Mood
|
|
Attached is extracts of "Explosives" by Brunswig (1909), shows the importance of initiator strength of the VOD of hydrogen-oxygen mixtures using in
5mm tubes. Its actual flame propogation through small openings is only 38m/s as determined by Bunsen (of "bunsen burner" fame). Detonated with mercury
fulminate or strong electric spark 2H2/O2 reaches ~2706m/s. I'm sure these are diametre dependant but theres some hard figures for you.
That and.. I really have a pet hate towards vague or non descriptive thread titles 
[Edited on 20-5-2006 by Axt]
Attachment: velocity-of-hydrogen-oxygen.pdf (855kB)
This file has been downloaded 1023 times
|
|
|
Boomer
Hazard to Others
Posts: 190
Registered: 11-11-2005
Member Is Offline
Mood: No Mood
|
|
Also, for you it is interesting whether it makes DDT on its own. I doubt it detonates in 5mm pipes without a blasting cap or a strong electric pulse
to kick-start it.
You might therefore have a look at:
Attachment: detonations in pipes and in the open.pdf (89kB)
This file has been downloaded 884 times
|
|
|
rsgpit
Harmless
Posts: 14
Registered: 19-5-2006
Member Is Offline
Mood: No Mood
|
|
But what about the larger balloons, would they detonate? Ive made up to 1yard diameter balloons with electrolysis, and they shake the bushes 30 feet
away. There are not dust clouds from moving earth though like in other HE's. It also is not a reaction that liberates gases. It makes water obviously,
but it is the high temperature steam that the heat makes that expands and creates the shockwave. If it does detonate in larger volumes just from a
fuse, It would be the easiest HE to make. Electricity+water.
|
|
|
Swany
Hazard to Others
Posts: 188
Registered: 11-4-2005
Location: My happy place...
Member Is Offline
Mood: Sanguine
|
|
I have a friend who electrolysed enough 3% H2O2 to make a garbage bag full, taped a fuse to it, and ignited while watching from a fairly close
distance, I belive he said 5m. Well, when the fuse ignited the mixture. He was thrown on his ass, deafened, and very surprised, as he expected a
fireball, not a sharp boom with no light.
My interest is piqued. 
|
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Seems to me electrolysis of H2O would leave a lean mixture, i.e. H2 diffused out of the bag. But then, H2O2 would be even more lean if anything.
Tim
|
|
|
nitro-genes
International Hazard
Posts: 1048
Registered: 5-4-2005
Member Is Offline
|
|
Why use H2O2 for electrolysis of water? A few % sulferic acid, and all alkaline earth metal cations in combination with phosphates, nitrates,
carbonates and hydroxy anions (the soluble ones) produce oxygen at the anode and hydrogen at the cathode in a 1:2 molar ratio...
If you add a little dishwash detergent to your electrolysis cell, the gas will be trapped in soapy bubbles on the surface which you can light with a
match. This will give an idea about its power. The smaller bubbles make an earringing bang, a very large one will shatter a glass cell...
|
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Heh, this one time I found bubbles on top of a chlorate cell being ran at a rather high voltage. (The bubbles were forming partly due to the graphite
scum floating about.)
Needless to say I won't attempt lighting such bubbles again 
Tim
|
|
|
enhzflep
Hazard to Others
Posts: 217
Registered: 9-4-2006
Member Is Offline
Mood: No Mood
|
|
I knew one particular individual, who is usually very particular, and would never light a match toward himself for fear of the danger (for lack of a
better analogy)
This one particular time, so he tells me, he decided to investigate just how explosive acetylene was. Okay thinks I, nothing too surprising to be
found out here. Until, he mentioned something about soap, water and a bathtub!
Yup, that's right he decided to test the stuff INDOORS, in the bathroom. LOL.
having mixed oxy and acetylene in water bombs (5cm diam - & one at a time), 1.25L soda bottles and 4L ice-cream buckets as kids on a mate's farm,
I could only imagine where this was leading...
Turns out he had "a fair few" - I didn't ask, bubbles filled with said mixture on top of the water when he threw the match in.
Cost him something like a hundred bucks to replace the window + another 5 years for the jokes about bubble-baths to stop. Not bad, for somebody who's
employed as an industrial chemist.
However, to get back on to topic - is anybody familiar with the dynamics of liquid hydrogen/oxygen rockets? Am wondering if the reaction proceeds at
the full 2706m/s. I.e is it a continuous detonation as it were, or 'mere' burning?
I read with interest that the two are mixed through mazes of very small holes, before being sent into the combustion chamber. I gather that it is to
effect greater mixing, with what I can only presume would be correspondingly high reaction rates.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
