thors.lab
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 103
Registered: 19-7-2019
Member Is Offline
|
|
Sodium benzoate -> Ferric benzoate (and similar rxns)
Hi,
I heard that using ferric salts can significantly improve yield in ketonic decarboxylation of carboxylate salts to produce things like butyrophenone
etc. This could be a very convenient method that doesn't require acyl chlorides which have proven to be extraordinarily hard for the amateur chemist
to acquire (seriously, I've been looking for ages and haven't found a single way to make them that's practical).
Now ferric benzoate and etc are pretty hard to just buy. But sodium benzoate is readily available. I'm not too familiar with this type of inorganic
reaction so I need a little help figuring out how or if I could convert these sodium salts to ferric salts.
Thanks,
|
|
DraconicAcid
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4298
Registered: 1-2-2013
Location: The tiniest college campus ever....
Member Is Offline
Mood: Semi-victorious.
|
|
One would normally mix ferric chloride/nitrate/whathaveyouate with sodium benzoate in a stoichiometric ratio, and expect the iron compound to
precipitate out. However, ferric compounds are notorious for hydrolyzing, so you'd be likely to get a basic ferric benzoate, or possibly just a mix
of rust and benzoic acid.
Please remember: "Filtrate" is not a verb.
Write up your lab reports the way your instructor wants them, not the way your ex-instructor wants them.
|
|
clearly_not_atara
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2725
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
I thought it was the ferrous salts?
Anyway you could start from ferrous sulfate and calcium benzoate or similar -- precipitating CaSO4 sucks of course though. Alternatively, if ferrous
tartrate is available, you can precipitate potassium bitartrate by using one component as the acid:
Fe(O2CCHOH)2 (aq) + H2(O2CCHOH)2 (aq) + RCO2H (aq) + KOBz (aq) >> "Fe(O2CR)(OBz)" (aq) + KH(O2CCHOH)2 (s)
For this I would try precipitating iron (II) carbonate from a solution of any iron (II) salt and dissolving this in a slight molar excess of boiling
aqueous tartaric acid; since the salt is attacked by air, the solution should be used immediately. However if you can buy ferrous tartrate itself that
would of course be easier.
[Edited on 10-11-2020 by clearly_not_atara]
|
|
karlosĀ³
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1520
Registered: 10-1-2011
Location: yes!
Member Is Offline
Mood: oxazolidinic 8)
|
|
Look for posts from organikum, somewhere he describes exactly that very detailed.
|
|