Junk_Enginerd
Hazard to Others
Posts: 251
Registered: 26-5-2019
Location: Sweden
Member Is Offline
|
|
Novelty/Interesting ways of generating continuous light?
I couldn't tell you why, but I have this fascination with lamps. Not just any lamps, but lamps that don't work like everyday lamps. And usually, if
I'm fascinated by something there's at least one person out there who is as well...
What are some interesting ways of generating(continuous) light? Doesn't have to be much, I'm mostly looking for the decorative aspect of it.
I've made a few small lamps based on fluorescence, getting the fluorescence from vitamins (riboflavin is the fluorescent one, yeah?), using glass
tubes as optical conductors and UV LEDs in water filled bulbs. Pretty cool and alien result.
I'm thinking a chemistry forum ought to contain people who know all kinds of odd ways of generating light.
I've yet to try making a discharge lamp or arc lamp, but I intend to get there eventually. Would be really interesting to try other elements than
commonly seen, like noble gases, look like. Maybe a sulfur discharge lamp? Or a potassium lamp? Just need to spend some time making a decent general
purpose discharge lamp driver...
|
|
|
Fyndium
International Hazard
Posts: 1192
Registered: 12-7-2020
Location: Not in USA
Member Is Offline
|
|
Could UV lasers be used in UV light catalyzed reactions? The laser beam could be lead into the vessel through a column instead through the glass,
because afaik soda and boro filters off the high energy UV light, and this way this filtering would be actually beneficial because now it prevents it
from exiting the vessel.
Pulsed and high energy lasers are what interest me. I've got a couple of the lower end handheld devices, 1W blue laser being the most powerful one.
|
|
|
MadHatter
International Hazard
Posts: 1346
Registered: 9-7-2004
Location: Maine
Member Is Offline
Mood: Enjoying retirement
|
|
Light production from laser
Maybe a little off topic but I found this article from a blog at
cartelligent.com very interesting.
February 10, 2016
Automobile headlights have evolved significantly in the past
several years from the incandescent beams of the past to halogens to LEDs. Laser headlights, which were first introduced in the BMW i8, take this even
further providing a brilliant white light to illuminate the road ahead.
BMW says that laser headlights can be up to 1,000 times brighter than an LED while consuming significantly less power. They can also light up to 6
times more road than traditional LED low beams, providing significantly increased visibility.
How do laser headlights work?
The first thing to understand is that laser headlights don’t actually shoot laser beams at the road ahead. Instead, three blue lasers fire their
beams onto a set of mirrors. The mirrors then focus the energy into a lens filled with yellow phosphorus which in turn emits an intense white light.
The reflected light from these beams is safe to be looked at directly.
Fyndium, I have a 30 watt, blue(450 nm) laser. I can light my cigarettes with it. 
From opening of NCIS New Orleans - It goes a BOOM ! BOOM ! BOOM ! MUHAHAHAHAHAHAHA !
|
|
|
Herr Haber
International Hazard
Posts: 1236
Registered: 29-1-2016
Member Is Offline
Mood: No Mood
|
|
Carbide lamps give the best light to appreciate your surroundings.
The spirit of adventure was upon me. Having nitric acid and copper, I had only to learn what the words 'act upon' meant. - Ira Remsen
|
|
|
clearly_not_atara
International Hazard
Posts: 2799
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
Cadmium-gallium arc lamp?
https://nvlpubs.nist.gov/nistpubs/ScientificPapers/nbsscient...
Beware of the toxicity of Cd.
|
|
|
organichem
Harmless
Posts: 19
Registered: 18-9-2013
Member Is Offline
Mood: No Mood
|
|
concerning lasers
Currently I am doing some work in a laserlab where the research group also needs some white-light continuum and therefore uses a Ti:sapphire-laser
that emits light with 800 nm. The frequency is then doubled to 400 nm and shot onto a rotating crystal of CaF2. Over some nonlinear optical
processes there is produced the wanted white-light continuum:
[img]https://www.researchgate.net/profile/Ivan_Buchvarov/publication/223648356/figure/fig2/AS:341363829821441@1458398887034/Spectra-of-the-white-light
-continuum-pulses-generated-in-CaF-2-LiF-and-MgF-2-crystal_W640.jpg[/img]
One can also use other optical non-linear substances like sapphire, MgF2, LiF, etc. DOI: 10.1016/S0030-4018(02)01107-0
|
|
|
Junk_Enginerd
Hazard to Others
Posts: 251
Registered: 26-5-2019
Location: Sweden
Member Is Offline
|
|
That was a really cool read. Back when scientific reports actually made sense, at least to a layman like me.
Though there's one big thing I'm not understanding here. There's that nice figure of the distillation setup and the capillary that gets sealed off...
but I don't understand what actually makes the lamp in the end. I would expect it to be the "bulb", which the alloy is being distilled into, but that
part doesn't have electrodes. Is the alloy being distilled out of the lamp, with the intent to only leave a tiny amount behind?
|
|
|
Chemetix
Hazard to Others
Posts: 376
Registered: 23-9-2016
Location: Oztrayleeyah
Member Is Offline
Mood: Wavering between lucidity and madness
|
|
I think I might have to try the cadmium lamp. Although I'll use a quartz halogen tube with it's modern molybdenum seals rather than the old fashioned
lead tungsten capillary.
Reading the exhaustive process of purifying the gallium, it almost feels like I'm cheating with the vial of four 9's galllium sitting in my desk
drawer.
|
|
|
unionised
International Hazard
Posts: 5128
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
If you are thinking of trying it, could you do a simple experiment for me; try using tin in place of gallium.
It also has a low melting point , will soften the cadmium and has a low vapour pressure.
It's also a good deal cheaper than gallium.
|
|
|
Junk_Enginerd
Hazard to Others
Posts: 251
Registered: 26-5-2019
Location: Sweden
Member Is Offline
|
|
Quote: Originally posted by Chemetix  | I think I might have to try the cadmium lamp. Although I'll use a quartz halogen tube with it's modern molybdenum seals rather than the old fashioned
lead tungsten capillary.
Reading the exhaustive process of purifying the gallium, it almost feels like I'm cheating with the vial of four 9's galllium sitting in my desk
drawer. |
Haha yeah, the part about the gallium was fascinating. "The little known element gallium" like it was an exotic artifact from a distant kingdom. I bet
that's exactly what it was, but still cool to get a glimpse of the time when what we now consider pretty basic stuff to be so unknown.
Are you saying halogen bulbs are quartz glass? That's very interesting if it's the case. Also, why the metal seals at all? I thought encasing a
tungsten wire in molten glass was a good enough seal for any purpose?
[Edited on 27-9-2020 by Junk_Enginerd]
| Quote: Originally posted by unionised | If you are thinking of trying it, could you do a simple experiment for me; try using tin in place of gallium.
It also has a low melting point , will soften the cadmium and has a low vapour pressure.
It's also a good deal cheaper than gallium. |
Seems unlikely it would work... I'm not basing that on chemistry knowledge, but rather that the author must have been aware of tin and dismissed it
for some reason. Tin was hardly exotic after all.
[Edited on 27-9-2020 by Junk_Enginerd]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
