Pages:
1
2 |
clearly_not_atara
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2732
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
All of these ideas are fine but they may be overkill. You might be able to just get a bucket of antifreeze -- ethylene or propylene glycol are both
fine -- and bubble the outgas through that. Hydrogen bonds and all. Bonus points if you can keep it cold.
If that's not enough, then we can start looking at acids/oxidizers/etc possibly as a second stage so it doesn't get used up as fast.
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3027
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
Quote: Originally posted by wg48temp9 ![](images/xpblue/lastpost.gif) | From wiki https://en.wikipedia.org/wiki/Drain-waste-vent_system
"In modern plumbing, a drain-waste-vent (or DWV) is part of a system that allows air to enter a plumbing system to maintain proper air pressure to
enable the removal of sewage and greywater from a dwelling. Waste is produced at fixtures such as toilets, sinks, and showers. As the water runs down,
proper venting is required to avoid a vacuum from being created. As the water runs down air must be allowed into the waste pipe either through a roof
vent, or the "drain waste vent." (or DWV)"
The vent does not have to be in roof. In some houses its external on an external wall. To work correctly the vent must be upstream of the flow not
down stream. It is possible to replace the vent with a one way valve that only allows air into the pipe but not out of the pipe. In the diagram the
drain on the left side of the main vertical pipe is fitted with such valve.
In some bodged systems with no vent or the vent in the wrong place when the bath is draining or the toilet is flushed the sink gurgles.
PS: What happens without the vent the water flow down the sewer forms a Sprengel vacuum pump that can suck the water out of other u bends, that
generates the gurgling sounds.
[Edited on 3/2/2020 by wg48temp9] |
In the Netherlands no one has a vent, really. As long as the diameters of the pipes are big enough you won't pull a vacuum anywhere and you won't need
an open connection to the sewer every other ten meters.
[Edited on 3-3-2020 by Tsjerk]
|
|
phlogiston
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1378
Registered: 26-4-2008
Location: Neon Thorium Erbium Lanthanum Neodymium Sulphur
Member Is Offline
Mood: pyrophoric
|
|
I'm Dutch too, and my house definitely does have a vent on the roof for the sewer.
I've had to repair it once, so I know exactly how the tubing runs from the space under the house, to the roof. My house was built in the early
seventies. Maybe different techniques for venting the sewers were used in different areas/times?
-----
"If a rocket goes up, who cares where it comes down, that's not my concern said Wernher von Braun" - Tom Lehrer
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Just a thought:
https://www.argos.co.uk/product/5787366
|
|
SWIM
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
Ozone sounds like an answer with lower maintenance and operating costs to me.
![ozone.jpg - 7kB ozone.jpg - 7kB](https://www.sciencemadness.org/whisper/files.php?pid=632031&aid=79723)
So blow the vented air through a box with one of these in it, or maybe even just an ozone bulb as Unionized suggested.
I'd probably try a large container like a 5 gallon bucket so the air is in there for a while with the uvc/ozone generator/whatever else makes ozone.
|
|
Twospoons
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1316
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
Ozone seems a likely candidate - I have an HV HF source I can test with. I'd build the O3 generator as a glass tube with inner and outer electrodes
and pass the waste air directly through the glow discharge to get the benefits of direct ionization, thorough mixing with O3, and UV light.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
Corrosive Joeseph
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 915
Registered: 17-5-2015
Location: The Other Place
Member Is Offline
Mood: Cyclic
|
|
/CJ
Being well adjusted to a sick society is no measure of one's mental health
|
|
SWIM
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
Hey, if you push that air/ ozone/ maggot stink mixture through a Dreschel bottle full of water you might get ammonium nitrate.
Make nitric acid from scratch, fertilize your garden, whatever.
I've read that Ozone will oxidize ammonia solution to ammonium nitrate, but I've yet to try it out.
At the very least it might retain the ozone long enough to help scrub the air one more time.
It is somewhat water soluble.
|
|
OldNubbins
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 136
Registered: 2-2-2017
Location: CA
Member Is Offline
Mood: Comfortably Numb
|
|
What about venting the box through 16-20 vertical ft. of black ABS pipe? You can tuck it up under a tree, the sun will warm the tube and add some
velocity to the gasses so they exit well above the area to disperse throughout the neighborhood.
|
|
Twospoons
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1316
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
I built a 600mm tall bubble tower using 100mm PVC drain pipe with a circular aquarium bubble stone at the bottom. The internal space is filled with
rings cut from 25mm PVC conduit, as a means of increasing the residency time of the bubbles.
For the acid fill I used 100g of oxalic acid in 3.5l of tap water. This fills the bubble tower to about 100mm from the top.
Timing the bubbles (by turning the pump on/off) I get a residence time of about 4 seconds.
Testing with a box of breeder flies that are just beginning to smell like week old rubbish bags ...
It works quite well - I can't smell rotting meat at all. There is a faint sulfurous smell, like extremely weak H2S, if I get my nose right up to it.
I would call this a success.
Thanks again for the suggestions, and the interesting discussion on the global variations on sewer plumbing ![:D](./images/smilies/biggrin.gif)
![StinkFilterInside.jpg - 1.3MB](https://www.sciencemadness.org/whisper/files.php?pid=632575&aid=79858)
[Edited on 14-3-2020 by Twospoons]
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3027
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
Nice! I'm interessed in how long it keeps working!
Are you planning on trying different acids? Cleaning acetic acid could be a cheap option.
[Edited on 14-3-2020 by Tsjerk]
|
|
Twospoons
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1316
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
Oxalic acid is ten bucks a kilo here (NZD) so its pretty cheap. It also doesn't smell. So long as it keeps working I'll keep using it, and I expect
the 100g I used in the scrubber will last quite a while.
Its also a surprisingly strong acid - I measured the pH with a cheap chinese meter (of dubious calibration) at 0.5. An online calculator predicted pH
0.6.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
Frankenshtein
Harmless
Posts: 25
Registered: 20-11-2018
Location: ahead
Member Is Offline
Mood: oligomerized
|
|
The traps in plumbing are there to prevent the sewer gases from entering the home. Best to leave those alone. You also dont want bugs to infest your
plumbing system. That could get extremely expensive.
I think a fan with activated charcoal is a good idea, sometimes laying baking soda around can also remove odors. Raising bugs is best done outdoors.
You could maybe create an air tight seal on their container and change out the air outdoors as well.
Oxalic acid is extremely toxic to pets or anyone else that might ingest it. It's what kills when ethylene glycol (antifreeze) is ingested. Ethylene
glycol should also not be inhaled, dont let it get hot. Propylene glycol is much safer but I dont know what to say about that. Read MSDS on everything
you work with.
[Edited on 19-9-2020 by Frankenshtein]
|
|
Pages:
1
2 |