XeonTheMGPony
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1640
Registered: 5-1-2016
Member Is Offline
Mood: No Mood
|
|
Using Sodium ethoxide to improve azide yeild
Hypothesis:
I am contemplating using some Sodium Ethoxide to compensate for the moisture content in the Sodium Hydroxide
I can not see any overt side reactions this could cause.
No matter how well I dry the Alcohol and the glass wear the sodium hydroxide is a much more difficult prospect, so instead of drying it consume burn
it off with Ethoxide.
Or am I out to lunch and missing some thing massive?
Proposed procedure:
Oven dry glass wear at 150c for 1 hour
Get purified Ethanol that has been distilled over sodium hydroxide and further dried over molecular sieve.
Sodium Hydroxide.
Assemble glass wear and drying tube (Thistle type with Calcium Chloride)
Add 100ml anhydrous ethanol, add 1 grams sodium metal
18.6g Sodium Hydroxide (at about assumed 5% moisture it will be about 0.93g of water)
While that all is dissolving / reacting:
Do hydrazine extraction with will resualt in 100Ml of the anhydrous ethanol / Hydrazine
Run reaction as per usual.
Any thing wrong with this proposed method?
|
|
Tsjerk
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3026
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
I would try to get dry NaOH, the stuff I get is dry, at least not more than 0,5% water. And it is just drain cleaner from the hardware store.
I can't comment on your proposed procedure because you don't give the full procedure, I don't know the "usual".
|
|