Jackson
Hazard to Others
Posts: 189
Registered: 22-5-2018
Location: U S of A
Member Is Offline
Mood:  Happy about new glassware
|
|
Steam distilation question
Hi, I dont currently have a distilation setup but I do have a boiling flask and a relatively high tempature tube that fits into it. I want to do some
steam distilation of orange and lemon peels to get the limonene. Could I stick the tube into the top of the flask with orange peels and water in it
and then put the end of the tube into a container of water or should I wait until I can get a real distilation setup?
|
|
|
Tsjerk
International Hazard
Posts: 3032
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
Wait, you will get suckback problems.
|
|
|
Jackson
Hazard to Others
Posts: 189
Registered: 22-5-2018
Location: U S of A
Member Is Offline
Mood: Happy about new glassware
|
|
Will i get suckback problems if I remove the tube from the water after it is done distilling and before it cools down?
|
|
|
Sulaiman
International Hazard
Posts: 3695
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
As long as you are boiling water / making steam / creating bubbles,
you will not get suckback.
What might happen if a (waxy) substance blocks the tubing ?
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
Tsjerk
International Hazard
Posts: 3032
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
As long as, but how are you going to react in less than seconds upon the moments it boils a bit less?
|
|
|
Polak Chem!
Harmless
Posts: 1
Registered: 10-7-2018
Member Is Offline
|
|
Patience!
I would invest in a cheap distilling setup.
There are some really cheap ones on ebay
|
|
|
BOBardment
Harmless
Posts: 32
Registered: 26-12-2018
Location: A random place
Member Is Offline
|
|
https://www.ebay.com/itm/Vacuum-Distillation-Apparatus-24-40...
33 bucks free shipping full distillation set. They also sell 1000ml and 2000ml and 24/40 distillation setups.
Pretty cheap investment for what you get out of it.
|
|
|
Swinfi2
Hazard to Others
Posts: 131
Registered: 19-2-2018
Location: England
Member Is Offline
Mood: Catalytic
|
|
If you have enough pieces you can cobble together something like this:
Inspired by one of nurdrage's videos.
From what you said i think your best option is (like i have here) a siphon return to the boiling flask and i can leave it (without refilling every 20
mins) for the 3 or so hours a steam distillation takes.
|
|
|
Ubya
International Hazard
Posts: 1247
Registered: 23-11-2017
Location: Rome-Italy
Member Is Offline
Mood: I'm a maddo scientisto!!!
|
|
Quote: Originally posted by Swinfi2  | If you have enough pieces you can cobble together something like this:
Inspired by one of nurdrage's videos.
From what you said i think your best option is (like i have here) a siphon return to the boiling flask and i can leave it (without refilling every 20
mins) for the 3 or so hours a steam distillation takes. |
the part of the message where he tells that he doesn't have a distillation kit, just a boiling flask and a tube should be enough to understand that
your setup can't be done
---------------------------------------------------------------------
feel free to correct my grammar, or any mistakes i make
---------------------------------------------------------------------
|
|
|
S.C. Wack
bibliomaster
Posts: 2419
Registered: 7-5-2004
Location: Cornworld, Central USA
Member Is Offline
Mood: Enhanced
|
|
No glass or video is necessary for steam distillation...the greatest need is an effective system that doesn't waste your time and materials. As usual
the OP tries to get around what is really needed, in this case a condenser, which can be just PVC with caps epoxied to copper tube and a couple holes
drilled in for water. A ground glass version will not perform better, get real steam from a steam generator for that.
A tube extending from the bottom of one's steam generator to above it may do wonders for pressure issues.
|
|
|
lordcookies24
Hazard to Self
Posts: 78
Registered: 2-1-2019
Location: pluto
Member Is Offline
Mood: curious
|
|
i would say invest in a distillation apparatus is worth it.
https://www.amazon.com/NANSHIN-Glassware-glassware-Distillat...
you can buy one for around $30
|
|
|
happyfooddance
National Hazard
Posts: 530
Registered: 9-11-2017
Location: Los Angeles, Ca.
Member Is Offline
Mood: No Mood
|
|
If you are looking at steam distillation to extract a small amount of limonene (5-10ml), you will need a flask or apparatus that can accommodate more
than 2L of plant matter. So basically a 5L flask.
If you are looking for a more reasonable amount (say, 50ml), you'd better start looking outside of glass, because you are not going to find glassware
that size (20L+) for cheap.
Also, if you are trying to really get limonene for the limonene, I wouldn't do it by steam distillation (though I have done it before), because it is
not efficient and is certainly not extracted this way commercially (despite what you may have read somewhere). I would extract it with a solvent
(since I don't have equipment to mechanically extract it, atm), dry over sodium sulfate, remove solvent, distill under vacuum.
This can be done for under $200.
|
|
|
Ubya
International Hazard
Posts: 1247
Registered: 23-11-2017
Location: Rome-Italy
Member Is Offline
Mood: I'm a maddo scientisto!!!
|
|
| Quote: Originally posted by happyfooddance | If you are looking at steam distillation to extract a small amount of limonene (5-10ml), you will need a flask or apparatus that can accommodate more
than 2L of plant matter. So basically a 5L flask.
If you are looking for a more reasonable amount (say, 50ml), you'd better start looking outside of glass, because you are not going to find glassware
that size (20L+) for cheap.
Also, if you are trying to really get limonene for the limonene, I wouldn't do it by steam distillation (though I have done it before), because it is
not efficient and is certainly not extracted this way commercially (despite what you may have read somewhere). I would extract it with a solvent
(since I don't have equipment to mechanically extract it, atm), dry over sodium sulfate, remove solvent, distill under vacuum.
This can be done for under $200.
|
i used a 1L erlenmeyer flask half full of peels (filled more i would get overflow in the condenser) and i got 5-6ml from a batch, if you use 1L round
bottom flask there's more surface for bubbles to escape so a 1L flask is ore than enough for small batches. i did 3 batches in 2 hours, the limonene
distills pretty much all at the beginning, i would distill 200ml of water (containing about 5ml of lemonene), clean the flask, separate the limonene
from the oil with a separatory funnel and repeat. if you can't go big just do more batches, there's no need to buy a 5L flask to distill some limonene
for fun
---------------------------------------------------------------------
feel free to correct my grammar, or any mistakes i make
---------------------------------------------------------------------
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
