abdo.samy
Harmless
Posts: 2
Registered: 24-11-2018
Member Is Offline
|
|
I want any way to get Soduim phosphide from Tri soduim phosphat
I want to know any way to get sodium phosphide from tri soduim phosphate
|
|
|
mayko
International Hazard
Posts: 1218
Registered: 17-1-2013
Location: Carrboro, NC
Member Is Offline
Mood: anomalous (Euclid class)
|
|
Welcome to the forum! In the future, this would probably be more appropriate in one of the other sections, like "Chemistry in General" or
"Beginnings".
Depending on your end use of the phosphide, you might try igniting a mixture of phosphate and magnesium or aluminum, then protecting the hot residue
from air to prevent oxidation. Brauer's preparative inorganic has this to say about calcium phosphide:
| Quote: |
If Ca3P3 is to be used only as a raw material for the preparation of PH3, it can be prepared by the aluminothermic method. The drawback of this
procedure is that the product phosphide cannot be separated from the Al2O3. Powdered, predried calcium phosphate (232 g.) and 108 g. of Al shot are
ground to a homogeneous mixture. An igniting mixture is used to kindle the reaction. In most cases it is necessary to preheat the crucible to 500°C.
|
You can find Brauer and much more in the forum library:
http://library.sciencemadness.org/library/index.html
Hope that helps!
al-khemie is not a terrorist organization
"Chemicals, chemicals... I need chemicals!" - George Hayduke
"Wubbalubba dub-dub!" - Rick Sanchez
|
|
|
j_sum1
|
Thread Moved
24-11-2018 at 14:30 |
abdo.samy
Harmless
Posts: 2
Registered: 24-11-2018
Member Is Offline
|
|
Thank you, iwill write in this sections next time,
Calcuim phosphide produced by calcuim phosphate and charcol is need high degrees at several hours,i feel cause sodiume phosphide had low melting
point ,it may need low condition for producing phosphide
|
|
|
AJKOER
Radically Dubious
Posts: 3026
Registered: 7-5-2011
Member Is Offline
Mood: No Mood
|
|
See pages 8 and also page 7 at http://www.hydrogendays.cz/2016/admin/scripts/source/present... .
Note, H+ + e- = .H (the hygrogen atom radical)
PH3 is a very toxic problematic gas, and does not readily react with bases either to produce phosphide salts. See Wikipedia at https://en.wikipedia.org/wiki/Phosphine, to quote on toxicity:
"Toxicity
Deaths have resulted from accidental exposure to fumigation materials containing aluminum phosphide or phosphine. It can be absorbed either by
inhalation or transdermally.[23] As a respiratory poison, it affects the transport of oxygen or interferes with the utilization of oxygen by various
cells in the body.[24] Exposure results in pulmonary edema (the lungs fill with fluid).[25] Phosphine gas is heavier than air so stays nearer the
floor where children are likely to play.[26]"
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
