hask123
Harmless
Posts: 3
Registered: 22-5-2018
Member Is Offline
|
|
Help Identifying Reaction
Can anyone help me identify what reaction is taking place?
I extracted some acetylsalicylic acid from aspirin using acetone, boiled off 85% of the acetone and then added a solution of sodium hydroxide to
produce sodium salicylate and sodium acetate. I then refluxed the solution for an hour but there was some solid in the flask.
Here's the problem. When I filtered the solution (which was yellowish brown) it turned green. At first I thought my apparatus was dirty but after
leaving it for a couple hours it went back to the yellowish brown colour. Then I shook it and it went green again.
Does anyone know what is going on here? I was thinking it might be some sort of reversible oxidation but i have no idea. Any help identifying this
would be much appreciated.
Here are pictures of before and after shaking
|
|
fusso
International Hazard
Posts: 1922
Registered: 23-6-2017
Location: 4 ∥ universes ahead of you
Member Is Offline
|
|
First of all, what's the source of the chemicals? Did they state how pure they are?
|
|
DavidJR
National Hazard
Posts: 908
Registered: 1-1-2018
Location: Scotland
Member Is Offline
Mood: Tired
|
|
In alkaline conditions, acetone has a tendency to undergo condensation reactions and polymerise into nasty gunk.
|
|
CobaltChloride
Hazard to Others
Posts: 239
Registered: 3-3-2018
Location: Romania
Member Is Offline
|
|
That's most certainly it. I know the color acetone tends to get after prolonged contact with sodium hydroxide and it is just like your solutions in
the picture.
|
|
hask123
Harmless
Posts: 3
Registered: 22-5-2018
Member Is Offline
|
|
My chemicals are all OTC. aspirin from the store, nail salon "100%" acetone, hardware variety lye, and tap water. Guess it's probably the acetone
polymerizing. Next time ill have to be more patient and properly dry or crystallize or by acetylsalicylic acid.
Thanks a lot for the input!
|
|
DavidJR
National Hazard
Posts: 908
Registered: 1-1-2018
Location: Scotland
Member Is Offline
Mood: Tired
|
|
Personally I don't use acetone as a solvent very often as it is just too reactive. I use it for cleaning glassware (which it's pretty good at) but it
wouldn't be my first choice for an extraction, recrystallization, or reaction solvent. Try using an alcohol instead (methanol, ethanol, or isopropanol
are cheap and useful).
[Edited on 29-10-2018 by DavidJR]
|
|