MöbiusMan
Harmless
Posts: 14
Registered: 13-7-2018
Location: Australia
Member Is Offline
Mood: studious
|
|
Making magnesium powder or bits for sodium hydroxide reduction
How can you break up magnesium ribbon into fine particles for use in making sodium-magnesium aggregate? Cutting it up is effort and takes ages so any
suggestions are appreciated.
If chemistry was easy it would be called biology.
|
|
VSEPR_VOID
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 719
Registered: 1-9-2017
Member Is Offline
Mood: Fullerenes
|
|
You turn a rock tumbler into a mill.
Within cells interlinked
Within cells interlinked
Within cells interlinked
|
|
TheMrbunGee
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 364
Registered: 13-7-2016
Location: EU
Member Is Offline
Mood: Phosphorising
|
|
blender?
|
|
j_sum1
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 6269
Registered: 4-10-2014
Location: Unmoved
Member Is Offline
Mood: Organised
|
|
Turnings would be the traditional route. Do you have access to a lathe or drill press?
How brittle is your Mg? My ingots crumble quite easily and I intend to give them a bit of a bash with a hammer.
|
|
Ubya
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1247
Registered: 23-11-2017
Location: Rome-Italy
Member Is Offline
Mood: I'm a maddo scientisto!!!
|
|
Quote: Originally posted by j_sum1 ![](images/xpblue/lastpost.gif) | Turnings would be the traditional route. Do you have access to a lathe or drill press?
How brittle is your Mg? My ingots crumble quite easily and I intend to give them a bit of a bash with a hammer. |
mhh he said magnesium ribbon, using a lathe or drill press would be ok with an ingot as you said, but with ribbon how would you do that?
maybe using first a blender to make fine-ish particles and then a ball mill to make them into powder.
trying to melt the ribbon into an ingot i suppose would end up in a metal fire
---------------------------------------------------------------------
feel free to correct my grammar, or any mistakes i make
---------------------------------------------------------------------
|
|
JJay
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
Is it safe to run magnesium ribbon through a blender? I imagine you'd cut or drill the roll into pieces first. I've run aluminum through a coffee
grinder, but magnesium seems more prone to sparking, and most people can't flush their blenders with argon.
|
|