arsenic
Harmless
Posts: 27
Registered: 15-9-2005
Member Is Offline
Mood: No Mood
|
|
Avoiding over-oxidation of mercaptans/sulfides
how can one avoid over-oxidation while using H2O2 as oxidant in oxidation reactions,(e.g oxidation of sulfides).
for instance:
sulfide ------------> sufoxide
sulfide ------------> sulfone over-oxidation
reaction conditions: room tem. acetonitrile as solvent,catalyst,H2O2(30%)
E.b.C: title
[Edited on 27-9-2005 by chemoleo]
|
|
Kinetic
Harmless
Posts: 45
Registered: 31-12-2004
Member Is Offline
Mood: fine
|
|
Overoxidation
I'll put as much effort into my post as you did in yours.
Use 1 equivalent of oxidant, or not much more. There is a good procedure for the enantioselective oxidation of thioethers to sulfoxides in Angew.
Chem. Int. Ed., 43, 4225-4228 (2004). I don't see why a similar protocol can't be used to give racemic sulfoxides,
without the addition of the chiral catalyst.
|
|
Sandmeyer
National Hazard
Posts: 784
Registered: 9-1-2005
Location: Internet
Member Is Offline
Mood: abbastanza bene
|
|
There are couple of procedures at orgsyn.org, scroll down to the bottom 3 links in the link that follows and links within them as well references
within the references might interest you: http://www.orgsyn.org/orgsyn/RxnTypes/section.asp?section=18...
Shulgin did this too in pihkal once, see, #173 TOMSO entry: http://www.erowid.org/library/books_online/pihkal/pihkal173....
Isn't it about time to turn these 4-thioethers of 2ct/ALEPH pattern to corresponding sulfones and sulfoxides? Would be an interesting
experiment.
|
|