neddy17
Harmless
Posts: 4
Registered: 17-12-2017
Member Is Offline
Mood: No Mood
|
|
Preparation of Methyl Iodide Using HCl Gas
I ran a reaction I'd been intending to try for a while today, producing a moderate yield of methyl iodide. I'm curious as to what you all think,
although having only done this once.
I dissolved potassium iodide in 50 mL of methanol, about 8g dissolved. I put some excess in thinking it may help force the equilibrium. With stirring,
HCl gas was bubbled in over 20 to 30 minutes from a NaCl/H2SO4 generator, probably at least a mole based on NaCl, but I didn't measure this. Over the
course of the gas introduction the mixture went from clear to cloudy, progressing from faint yellow to fairly red. After gas addition, I let it stir
for another 30 mins and distilled. I collected two fractions, the first up until about 50 C, which had a density of 1.62 g/mL, 2.2g total. The second,
up until about 58 C had a density of 1.25 g/ml, 3.5 g total. Ran an NMR on the first, with a peak at 2.2 ppm integrating to 40% of total. Pretty clean
spectra with no water. Other than methanol, just a broad singlet around 2.6 which I have yet to identify.
I did this with ebay KI and hardware store acid and methanol, didn't dry anything at all. I was actually thinking catalytic water may help with acid
dissociation, not sure how well HI dissociated in MeOH. But this seems moderately successful, and I think worth scaling up. Next time, I might reflux
before distilling, but I'm not sure if this would cause me to lose too much HI. I might also distill to dryness and then fractionally distill the
distillate. Any input?
|
|
KiWiki
Harmless
Posts: 12
Registered: 30-11-2017
Member Is Offline
Mood: No Mood
|
|
1) Source?
2) A strong acid will release a weaker acid. Since HI(aq) is the stronger acid nothing will happen:
KI(aq) + HCl(g) -> KI(aq) + HCl(g) (equilibrium)
3) There is no way to get good yields (over 10%) by the reaction of methanol to methyl iodide by solid KI or NaI with combined with a stronger acid.
Prepare PI3 instead (P and iodine in DCM) and let PI3 react with MeOH
4) For the entire procedure please: UTFSE
|
|
DJF90
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2266
Registered: 15-12-2007
Location: At the bench
Member Is Offline
Mood: No Mood
|
|
Actually KiWiki, theres a nice write up in the Prepublications section on the preparation of MeI using KI and H3PO4, by Arrhenius, where yields in
excess of 80% were reported.
Whilst you're right about the equilibrium between HCl and HI, hydrogen iodide does not need to be formed in situ - it is the methanol that needs to be
protonated, and the iodide can then displace the water.
|
|
Melgar
Anti-Spam Agent
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2004
Registered: 23-2-2010
Location: Connecticut
Member Is Offline
Mood: Estrified
|
|
I was going back and forth over whether this would work or not. My hunch is that it would work, just not very well, and that phosphoric acid would
work a lot better as the acid, since it'd make for an easier workup.
The first step in the process of learning something is admitting that you don't know it already.
I'm givin' the spam shields max power at full warp, but they just dinna have the power! We're gonna have to evacuate to new forum software!
|
|
Niter of Potash
Harmless
Posts: 13
Registered: 28-12-2016
Member Is Offline
Mood: No Mood
|
|
I guess that first MeCl is formed, and then Cl in methyl cholride gets swapped for I from KI, forming MeI + KCl. KCl should then fall out from
solution driving reaction forward.
NurdRage used similar "trick" in his pyrimethamine synthesis, step 5, when he turned p-chlorobenzyl chloride into p-chlorobenzyl iodide, only using
acetone as solvent in that case.
|
|
Melgar
Anti-Spam Agent
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2004
Registered: 23-2-2010
Location: Connecticut
Member Is Offline
Mood: Estrified
|
|
Quote: Originally posted by Niter of Potash ![](images/xpblue/lastpost.gif) | I guess that first MeCl is formed, and then Cl in methyl cholride gets swapped for I from KI, forming MeI + KCl. KCl should then fall out from
solution driving reaction forward.
NurdRage used similar "trick" in his pyrimethamine synthesis, step 5, when he turned p-chlorobenzyl chloride into p-chlorobenzyl iodide, only using
acetone as solvent in that case. |
Nope, the reaction you're referring to is the Finkelstein reaction, and works due to the fact that sodium iodide has a anomalously high solubility in
acetone compared to sodium chloride.
This reaction works because iodide ions have an easier time donating electrons than chloride ions do, since its valence electrons are further away
from the nucleus. And because this is an aqueous solution, it makes more sense to think of it as a bunch of K+, H+, Cl-, and I- ions floating around,
none of which is permanently attached to any other one. Thus, for this reaction the K+ and Cl- ions are nonparticipants.
The first step in the process of learning something is admitting that you don't know it already.
I'm givin' the spam shields max power at full warp, but they just dinna have the power! We're gonna have to evacuate to new forum software!
|
|
JJay
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
Quote: Originally posted by Melgar ![](images/xpblue/lastpost.gif) | I was going back and forth over whether this would work or not. My hunch is that it would work, just not very well, and that phosphoric acid would
work a lot better as the acid, since it'd make for an easier workup. |
Nicoderm posted an experiment where he stored methanol, reagent grade HCl, and sodium iodide for a week in a bottle, and the results were pretty
convincing and the yields were well over 50% despite the lack of optimization. I am pretty sure it would work with potassium iodide unless there are
solubility issues (I didn't see any but didn't spend a great deal of time looking).
|
|
sykronizer
Harmless
Posts: 17
Registered: 16-12-2017
Member Is Offline
Mood: omnivorous
|
|
Is that some smoking cessation patch you are referring to there, is it ? .......
|
|
JJay
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
*Nicodem
He's a highly respected moderator who has made many contributions.
See: http://www.sciencemadness.org/talk/viewthread.php?tid=65075
[Edited on 28-12-2017 by JJay]
|
|
Melgar
Anti-Spam Agent
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2004
Registered: 23-2-2010
Location: Connecticut
Member Is Offline
Mood: Estrified
|
|
He also seems to be in his element when he's grouchy. Some of his best posts are calling out people who don't know what they're talking about, but
pretend to. I get the feeling he's dabbled in the dark arts in his younger days, and doesn't see anything wrong with that, as long as you're doing
something new and interesting.
The first step in the process of learning something is admitting that you don't know it already.
I'm givin' the spam shields max power at full warp, but they just dinna have the power! We're gonna have to evacuate to new forum software!
|
|