NZniceguy
Harmless
Posts: 48
Registered: 16-9-2017
Member Is Offline
Mood: No Mood
|
|
Chaser solvent for Acetic Anhydride and Glacial Acetic Acid fractionation
Im trying to seperate an acetic acid/acetic anhydride solution by fractionating(fractionation?) and as I lose a bit at the end and am only doing small
amounts 20 to 100mls at a time. What I need is a chaser solvent that has a boiling point higher than 138 degrees C and wont react with the acid or
anhydride..................any suggestions?
|
|
clearly_not_atara
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2725
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
According to the azeotrope table on Wikipedia, acetic acid forms an azeotrope with toluene in a 72% toluene / 28% AcOH ratio. I think that might help.
Otherwise propylene carbonate has a very high boiling point of 242 C so it's probably fit for the original purpose.
|
|
karlosĀ³
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1520
Registered: 10-1-2011
Location: yes!
Member Is Offline
Mood: oxazolidinic 8)
|
|
Is it AcOH or Ac2O which you have in excess? If the latter, following procedure would be suitable:
add enough acetanhydride to the free acid, to react any water present to additional AcOH, which is the standard method for absolution of acetic acid.
|
|