BuzzKillerOfFire
Harmless
Posts: 5
Registered: 24-2-2017
Member Is Offline
Mood: No Mood
|
|
Mold in condenser water reservoir
I have a small amatuer lab, and am using a 12v ebay diaphram pump and a home depot bucket for my condenser water. Today I noticed some cloudiness in
my tubes, and think it might be mold. What would be a good way to solve this? (biocidal agents, etc. Ideally over the counter).
|
|
gdflp
|
Thread Moved 11-7-2017 at 06:41 |
Fulmen
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1704
Registered: 24-9-2005
Member Is Offline
Mood: Bored
|
|
Basically anything toxic or corrosive to life. A bit of sodium hydroxide would probably work, but it can attack some polymers over time. Salt is also
effective against most microbes, but it will be more corrosive to metals. Copper salts should work, it's a traditional agent for killing algae, tree
roots and similar. Bleach is also highly effective.
But the first thing to do is to limit light exposure, this will limit the number of microbes that can survive.
We're not banging rocks together here. We know how to put a man back together.
|
|
JJay
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
It could easily be hard water residues; these can be dissolved in most acids (I usually use cleaning vinegar), but don't use sulfuric acid or they may
become permanent. If it is mold, bleach works well.
|
|
gdflp
Super Moderator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1320
Registered: 14-2-2014
Location: NY, USA
Member Is Offline
Mood: Staring at code
|
|
A few crystals of copper sulfate works as a very effective biocide in a closed water loop. Not too corrosive, but effective at preventing bacterial
growth. Small silver coils are also available relatively cheaply for this purpose in watercooled computers.
|
|
XeonTheMGPony
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1640
Registered: 5-1-2016
Member Is Offline
Mood: No Mood
|
|
Old thread but clear tubing will go cloudy over time in contact with water sterile or not.
But I use clean water with some methanol in it, and all my tubing looks cloudy, take it off and let it dry perfectly clear again.
As said shock it with bleach let sit for a day then drain, refill with clean fresh water and add a tea spoon of copper sulfate to it, or if sealed
methanol.
|
|