popscience
Harmless
Posts: 1
Registered: 16-7-2017
Member Is Offline
Mood: No Mood
|
|
Drying raw materials temperature prior to Soxhlet extraction
What is the optimum temperature to dry plant based samples in an oven so as not to destroy the plant composition? The dried samples are going to be
used for Soxhlet extraction.
[Edited on 17-7-2017 by popscience]
|
|
Fulmen
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1702
Registered: 24-9-2005
Member Is Offline
Mood: Bored
|
|
Room temperature? Takes a while, but should retain everything but the most volatile components. Freeze drying would be even better. That's not as hard
as it might sound, but you do need a vacuum pump that can run for extended periods.
If you use a high boiling solvent that isn't miscible with water you can extract wet material using a Dean-Stark attachment to separate out the water.
It works very well with toluene, but other solvents should work as well. Basically the solvent should have a lower density and higher boiling point
than water.
We're not banging rocks together here. We know how to put a man back together.
|
|
Ozone
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1269
Registered: 28-7-2005
Location: Good Olde USA
Member Is Offline
Mood: Integrated
|
|
You can grind (mortar and pestle) it with anhydrous magnesium sulfate until a fine powder is obtained. Extract that.
O3
-Anyone who never made a mistake never tried anything new.
--Albert Einstein
|
|
DrP
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 625
Registered: 28-9-2005
Member Is Offline
Mood: exothermic
|
|
Vacuum oven? 40C or so with reduced pressure should strip off any water or solvent.
\"It\'s a man\'s obligation to stick his boneration in a women\'s separation; this sort of penetration will increase the population of the younger
generation\" - Eric Cartman
|
|
feacetech
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 163
Registered: 12-2-2007
Member Is Offline
Mood: No Mood
|
|
I have dried fungus at 40C over threes days (closed air oven), but it proably depends on the water activity.
I used to also dry stuff in a vacuum oven but the hot plate on the bottom wasnt very good and often over cooked things.
Most plant material can be dried in a humidty controlled environment at room temperatures
|
|