Steamboy
Harmless
Posts: 12
Registered: 24-1-2017
Member Is Offline
Mood: No Mood
|
|
Alternatives to sulphuric acid for make ethyl borate
I am trying to make triethyl and trimethyl borate, however I don't have the concentrated sulphuric acid needed for the classical reaction of boric
acid and methanol/ethanol.
What I can use or do?
|
|
Hexavalent
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1564
Registered: 29-12-2011
Location: Wales, UK
Member Is Offline
Mood: Pericyclic
|
|
The preparation of borate esters has been discussed before.
http://www.sciencemadness.org/talk/viewthread.php?tid=10778
I suspect that concentrated phosphoric acid could also be used instead of sulfuric acid, however if you can't access sulfuric then I imagine you don't
have phosphoric either.
Concentrated sulfuric acid is available in many regions as drain cleaner. Look for white plastic bottles, usually in a plastic bag as secondary
containment. It may have some contamination but is usually fine; if it's particularly dirty then cleaning by distillation should resolve the matter.
However, if you ask a question like the one above, then you should steer clear of attempting this. I'm not being condescending, but boiling sulfuric
acid is really not something to be taken lightly.
You may be able to find phosphoric acid OTC as rust remover or a similar product, though I believe that concentrations can vary significantly between
regions and manufacturers.
[Edited on 4-2-2017 by Hexavalent]
"Success is going from failure to failure without loss of enthusiasm." Winston Churchill
|
|
Texium
|
Thread Moved 4-2-2017 at 09:11 |
nezza
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 324
Registered: 17-4-2011
Location: UK
Member Is Offline
Mood: phosphorescent
|
|
The sulphuric acid acts a a catalyst and a desiccant removing the water produced by the reaction. I doubt phosphoric acid would work anything like as
well.
If you're not part of the solution, you're part of the precipitate.
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by nezza ![](images/xpblue/lastpost.gif) | The sulphuric acid acts a a catalyst and a desiccant removing the water produced by the reaction. I doubt phosphoric acid would work anything like as
well. |
It doesn't need to work as well as sulphuric acid; it needs to work better than nothing.
|
|
ave369
Eastern European Lady of Mad Science
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 596
Registered: 8-7-2015
Location: No Location
Member Is Offline
Mood: No Mood
|
|
Metaphosphoric acid might work. It's an even better desiccant than sulfuric acid. However, it's a pain in the rear to make, because it is made by
calcining phosphoric acid, and when hot it eats glass.
[Edited on 5-2-2017 by ave369]
Smells like ammonia....
|
|
DJF90
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2266
Registered: 15-12-2007
Location: At the bench
Member Is Offline
Mood: No Mood
|
|
Start with boric anhydride. It can be made by heating the acid under suitable conditions.
|
|
Melgar
Anti-Spam Agent
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2004
Registered: 23-2-2010
Location: Connecticut
Member Is Offline
Mood: Estrified
|
|
Making alkyl borates is actually stupidly easy, if the alcohol forms a low-boiling azeotrope with water, or has a higher boiling point than water. I
believe this is true of every alcohol except methanol. You just add boric acid to your anhydrous alcohol, then heat it to boiling. This has been
confirmed to work with n-butanol and even isopropanol, and almost certainly works with ethanol. However, there's a good chance that what's being
produced is mono- and di- alkyl borates and not the trialkylborates, but if your goal is say, making a solution that burns green, this is good enough.
With longer-chain alcohols though, the flame will be yellow due to soot formation/black body radiation, so you may need a special burner to see the
green color very well.
|
|
clearly_not_atara
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2725
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
Boron trioxide can itself serve as the dehydrating agent at a cost of 50% theoretical yield relative to boron:
B2O3 + 3ROH >> (RO)3B + B(OH)3
I think it is possible to distill trimethyl borate out of the rxn mixture if the methanol is entirely consumed. Otherwise the boiling point of
methanol is lower than that of trimethyl borate.
Also, I suddenly had a thought:
B2O3 (l) + 2NaPO3 (l) >> 2 NaBO2 (l) + P2O5 (g)?
B2O3 boils at 1800 C. P2O5 however boils at a mild 360 C.
|
|