mayilvaganan
Harmless
Posts: 1
Registered: 21-10-2016
Member Is Offline
Mood: No Mood
|
|
Amount of H2 required
4H2 + CO2 --> CH4 + 2H20 .
What is the volume of hydrogen required (in cu.m or cu.m/h) if it combines with 490 cu.m/h of CO2 to produce 575 cu.m/h of CH4?
|
|
|
AJKOER
Radically Dubious
Posts: 3026
Registered: 7-5-2011
Member Is Offline
Mood: No Mood
|
|
A more fundamental question, ask your teacher if the cited volume of methane produced is measured at a different temperature than the CO2?
If the teacher cannot give an answer or says no, I think you may have a much bigger problem,
|
|
|
Metacelsus
International Hazard
Posts: 2539
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
To elaborate, something is odd with this question. Assuming ideality and constant temperature and pressure, each mole of gas occupies the same volume.
Thus, 490 cubic meters of carbon dioxide should produce 490 cubic meters of methane if the temperature and pressure are constant and the gases can be
considered ideal.
|
|
|
Chemetix
Hazard to Others
Posts: 375
Registered: 23-9-2016
Location: Oztrayleeyah
Member Is Offline
Mood: Wavering between lucidity and madness
|
|
I am going to say that you need 4 mol of H2 (at some standard temperature and pressure) and 1 mol of CO2 also at the same temp. and pressure. Ergo, H2
volume is 4 times the volume of CO2. It gets complicated when you start playing with rates because the arrow would not point one way exclusively, in
fact the arrow is more favoured running the other way( making hydrogen and CO2 but at high temperature).
But I don't think this is a chemical engineering question, more a beginners fundamental chemistry sort of thing.
So the principle of 1mol of gas occupying 22.4l at STP is likely the point being made.
|
|
|
aga
Forum Drunkard
Posts: 7030
Registered: 25-3-2014
Member Is Offline
|
|
STP changed a while back, as in 34 years ago.
IUPAC STP is 273K at 100kPa
It throws the 22.4 thing out a little.
Just enough to lose points in an exam if the examiner still uses the older definition.
|
|
|
Chemetix
Hazard to Others
Posts: 375
Registered: 23-9-2016
Location: Oztrayleeyah
Member Is Offline
Mood: Wavering between lucidity and madness
|
|
Damn I've just given away my age
But not that old...Aus used the 22.4 value only up until somewhat recently in the education system (10 yrs? exactly when I cant remember) And started
using SLC standard laboratory conditions, which give a molar volume of 24.5L.
The IUPAC STP will give a molar volume of 22.71L. This being an international site makes assumptions about which definition is being used sometimes
difficult
[Edited on 21-10-2016 by Chemetix]
|
|
|
aga
Forum Drunkard
Posts: 7030
Registered: 25-3-2014
Member Is Offline
|
|
The 'S' in STP is for 'Standard' so some measure has to be adopted by all.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
