FPMAGEL
Hazard to Self
Posts: 74
Registered: 10-5-2005
Member Is Offline
Mood: No Mood
|
|
Magnesium sulphide
I,ve been looking up about steel and i came across a pargraph about PETN and MgS and how when it goes of and burns so hot it can cut throught steel.
I was thinking about heating Mg and sulpher in a argon.
Ideas?thanks
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Ouch, sounds explosive. I seem to recall Zn + S is volatile enough...
You can get it by reduction of sulfides with magnesium, but most of that goes up as smoke as it is a fast-burning pyrotechnic composition. It does leave a brown stinky residue though.
Epsom salts mixed with charcoal would surely do it, might take as much as yellow heat to complete though.
Tim
|
|
chemoleo
Biochemicus Energeticus
Posts: 3005
Registered: 23-7-2003
Location: England Germany
Member Is Offline
Mood: crystalline
|
|
Well it should be a reaction similar to the one between Al and S- which is very energetic.
Try to react magnesium filings with a slight stoichiometric excess of sulphur, and light with a sparkler or something. The reaction is likely to be
energetic, so be careful!
Al + S is easily hydrolysed, and MgS is likely to do the same, so avoid water!
Never Stop to Begin, and Never Begin to Stop...
Tolerance is good. But not with the intolerant! (Wilhelm Busch)
|
|