underground
National Hazard
Posts: 707
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
Optimum temp for nitration of ETN ?
What is the best temp for nitration of ETN ? I have seen some people go at 5-7°C. Other close to 15°C. At some patents up to 45°C. Also what the
temp must be when we add the nitrate salt (AN,KNO3,NaNo3 e.t.c.) into H2SO4 ? How much the temp affect the final yields ?
[Edited on 4-12-2015 by underground]
|
|
|
TheAlchemistPirate
Hazard to Others
Posts: 151
Registered: 25-3-2014
Location: The point of no return
Member Is Offline
Mood: Enigmatic
|
|
Finally a thread relevant to what I have worked on recently...
In my experiments the most etn forms at the highest possible temperature, and the longer nitration periods. That means if you can keep your nitration
solution at 20 C without a runaway, go for it. With lower temperatures such as 10 C,I get very poor yields. This is when it reacts for 25 minutes. It
seems that temperature very much affects yields in this reaction.
When adding the nitrate salt to the H2SO4, I keep it below 20 C, and add the nitrate salt slowly of course. After the addition of the nitrate salt
is complete, I bring the mixed acids to room temperature and stir. If this causes the solution to heat rapidly, I place it back into the ice bath and
repeat until the temperature only rises gently. I believe this ensure that all the reagents in the mixed acids are reacted, which seems to
be very important.
As far as the nitration, I bring the solution to 15 C and begin adding the erythritol. As the erythritol is added in portions, the temperature is
alternately brought between 15 and 20 C,to ensure the reaction is actually taking place. After the erythritol addition is complete, I bring the
solution to 20 C and monitor the reaction at that temperature for 25-30 minutes. This had a 50% yield. (put in 7 grams erythritol, got 7 grams
erythritol tetranitrate) I will try this again with a 1 hour nitration period, which I believe should give a better yield.
"Is this even science anymore?!"
|
|
|
Gargamel
Hazard to Others
Posts: 166
Registered: 9-3-2013
Member Is Offline
Mood: No Mood
|
|
I would expect ETN to have a high chance of nasty explosions in case of a runaway.
My last batch was done at 5° C and the yield was about 1g ETN per 1g erythritol.
At 20°C I got about 1,2 - 1,3g
It seems like the reaction stops at some point. Some PETN reports mention heating the batch after the reaction has died down...
When doing this I've had good yields but also constant reddish clouds under crazy stirring. I'm very afraid doing this with ETN.
[Edited on 5-12-2015 by Gargamel]
|
|
|
NeonPulse
Hazard to Others
Posts: 417
Registered: 29-6-2013
Location: The other end of the internet.
Member Is Offline
Mood: Isolated from Reality! For Real this time....
|
|
I have kept the temperature of my ETN batches to around 20-25c through out the process.although once something very briefly needed my attention and
the temp got as high as 36c without incident. Rapid stirring controlled the reaction so I suspect that there is quite some leeway from temperatures
that cause a runaway. This temp 20-25c makes for a much smoother and complete nitration by not allowing the unnitrated polyol to gather up,preventing
a runaway reaction.
This is for mixed acids though. I'm not too sure if a nitrate salt mixture would be OK or not since it is much thicker making the temp harder to
regulate. Too cold and a runaway may well happen since the erythritol nitrates too slowly and builds up so when the temp gets too high the build up
begins to nitrate too fast causing problems. About a half hour after the last addition is good enough for a 10-15 g batch and in my experience the
method scales up ok if 70% nitric is used.
|
|
|
underground
National Hazard
Posts: 707
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
When i add a nitrate salt to H2SO4, some nasty fumes comes out. From were these fumes comes ? Is it because nitric acid evaporates ? But the boiling
temp of nitric acid is close to 80°C
|
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
Quote: Originally posted by underground  | What is the best temp for nitration of ETN ? I have seen some people go at 5-7°C. Other close to 15°C. At some patents up to 45°C. Also what the
temp must be when we add the nitrate salt (AN,KNO3,NaNo3 e.t.c.) into H2SO4 ? How much the temp affect the final yields ?
[Edited on 4-12-2015 by underground] |
can you please provide me with the patents since I am interested.
|
|
|
underground
National Hazard
Posts: 707
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
| Quote: Originally posted by ecos | | Quote: Originally posted by underground | What is the best temp for nitration of ETN ? I have seen some people go at 5-7°C. Other close to 15°C. At some patents up to 45°C. Also what the
temp must be when we add the nitrate salt (AN,KNO3,NaNo3 e.t.c.) into H2SO4 ? How much the temp affect the final yields ?
[Edited on 4-12-2015 by underground] |
can you please provide me with the patents since I am interested. |
http://www.wydawnictwa.ipo.waw.pl/cejem/vol-10-03-2013/Kunze...
|
|
|
Gargamel
Hazard to Others
Posts: 166
Registered: 9-3-2013
Member Is Offline
Mood: No Mood
|
|
@underground:
cool your acid before you add the nitrate, add it slowly and stirr while you do it.
Thus you prevent your acid from decomposing.
|
|
|
TheAlchemistPirate
Hazard to Others
Posts: 151
Registered: 25-3-2014
Location: The point of no return
Member Is Offline
Mood: Enigmatic
|
|
H2SO4 reacting with a nitrate salt to form HNO3 is an exothermic reaction, similar to a runaway reaction. If the temperature gets way too high and the
nitric acid starts decomposing, red fumes of nitrogen dioxide are given off. If white fuming nitric acid (formed when you add H2SO4 to a nitrate salt)
contacts airi above about 10 C, it evaporates(fumes) and a choking white mist comes out. This isn't decomposition however.
"Is this even science anymore?!"
|
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
Thanks dear for the reply but this is not a patent 
|
|
|
underground
National Hazard
Posts: 707
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
Yea you have right, i did not notice that.
[Edited on 5-12-2015 by underground]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
