Cesium Fluoride
Harmless
Posts: 48
Registered: 26-1-2005
Member Is Offline
Mood: Cupric
|
|
Coldest Reported Eutectic with Ice?
Hi everyone,
What is the lowest reported eutectic for an ice-solid mixture without any co-solvents?
The lowest I know of is the CaCl2-H2O system, which is around -50 C. I vaguely recall reading about lower ones (perhaps with
perchlorates?), but I can't remember where.
Thanks for your help.
P. S. It's been many years since I've been on this site- thanks for all of the great memories.
|
|
|
BromicAcid
International Hazard
Posts: 3244
Registered: 13-7-2003
Location: Wisconsin
Member Is Online
Mood: Rock n' Roll
|
|
Instead of simply eutectic, do you mean a frigorific mixture?
|
|
|
Pok
potassium Prometheus
Posts: 176
Registered: 5-12-2010
Member Is Offline
|
|
This could be the source you remembered (about silver perchlorate): "The eutectic temperature, -58.2°, is lower than that of any other true
salt in water, and only in the cases of hydrogen chloride in water, potassium hydroxide in water, and sulfuric acid in water have lower eutectics been
found. "
Eutectic points (with water) from other sources:
H2SO4: ca. -65 °C
KOH: -65.2 °C
HCl: ca. -86 °C
But more recent literature contradicts this statement, because there are other "true salts" with lower eutectic points than silver perchlorate:
Fe2(SO4)3: -68 °C [source]
Mg(ClO3)2: -69 °C [source]
CaI2: -77 °C
CaBr2: -83 °C [source for both]
Also NH3-H2O has a lower eutectic point (about -98 °C).
Alkaline earth perchlorates:
http://link.springer.com/article/10.1007%2Fs11167-005-0306-z
I think CaBr2 is the best candidate if you want a solid/water eutectic.
[Edited on 27-11-2015 by Pok]
|
|
|
User123
Harmless
Posts: 40
Registered: 31-10-2015
Member Is Offline
Mood: No Mood
|
|
Exactly what should be done to get to -50C with calcium chloride and ice? I have tried mixing them and it does not seem to get very much colder than
the ice alone. The ice simply melts. Am I doing something wrong, or SHOULD that be as easy as it is?
|
|
|
Pok
potassium Prometheus
Posts: 176
Registered: 5-12-2010
Member Is Offline
|
|
You have to use the dry hexahydrate, mix it in the correct proportion (eutectic!) with dry snow or dry and finely ground ice,
insulate the container, precool the ingredients. Every single point is important to get close to -50 °C.
[Edited on 27-11-2015 by Pok]
|
|
|
Metacelsus
International Hazard
Posts: 2539
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
Yes, don't use the anhydrous salt, as that will produce heat upon hydration.
|
|
|
User123
Harmless
Posts: 40
Registered: 31-10-2015
Member Is Offline
Mood: No Mood
|
|
My method was to dissolve some calcium chloride in cold water, then add lots of ice to it.
Anyway, thanks for the suggestion, I'll try intimately mixing them with a pestle and mortar, and see if I can solidify some appropriate solvents,
since I don't have a sub-zero thermometer.
Any idea on the correct proportion? I did a little searching for correct eutectic proportions, but physical chemistry is not my forte, and it hampered
my searching.
|
|
|
Cesium Fluoride
Harmless
Posts: 48
Registered: 26-1-2005
Member Is Offline
Mood: Cupric
|
|
Thanks Pok for the wonderful information. This is exactly what I was looking for and more!
|
|
|
alive&kickin
Hazard to Others
Posts: 100
Registered: 10-11-2012
Member Is Offline
Mood: No Mood
|
|
Searching I found this: https://the-hive.archive.erowid.org/forum/showflat.pl?static.... Hope it helps if this is what someone is looking for.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
