quantumcorespacealchemyst
Banned Shitposter
Posts: 213
Registered: 17-10-2014
Member Is Offline
Mood: No Mood
|
|
is the reaction of arsenic and iodide exothermic to a large degree, or is it more like mercury and iodine which react slowly and without much heat
generation?
is the reaction of arsenic and iodide exothermic to a large degree, or is it more like the reaction of mercury and iodine (which react slowly and
without much heat generation)?
i had attempted an amalgam of mercury and arsenic and found that they don't amalgate on online literature and realized there was only clumping in the
flask.
after decanting the majority of the mercury to a bottle, the remaining mass of As/Hg clumps were added iodine.
so untill i find my misplaced notes there is 9.596g ?As:?Hg(ratio) and 24.711g Iodine. So possibly there will be a good data yield to calculate AsI3
to mercury iodides (Hg2I2/HgI2 ?). the arsenic iodides sublime reportedly so i hope to purify by sublimating with a cold finger and weighing the
scraped precipitate(sublimate?).
|
|
|
Tdep
National Hazard
Posts: 519
Registered: 31-1-2013
Location: Laser broken since Feb 2020 lol
Member Is Offline
Mood: PhD is done! It isn't good but it's over lol
|
|
God.
|
|
|
woelen
Super Administrator
Posts: 8027
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
Sublimating arsenic iodide in a home/amateur setting? Are you trolling?
|
|
|
gardul
HAZARD TO TEH CATZ!
Posts: 256
Registered: 18-10-2014
Location: Under the Sun in a beaker
Member Is Offline
Mood: Vivified!
|
|
I sure the hell hope this is a trolling thing... and if he isn'tlets hope he doesn't live in an appartment or have other living beings in his/her
dwelling.
I just made you read this very pointless signature. How does it feel?
|
|
|
AJKOER
Radically Dubious
Posts: 3026
Registered: 7-5-2011
Member Is Offline
Mood: No Mood
|
|
Apparently, AsI3 is a pharmaceutical preparation! Well at least once upon a time as Atomistry in its historical excerpts from the literature can be
quite dated and I do recall a movie "Out of Africa" based the life of Baroness Karen Blixen, a Danish woman who emigrated to Kenya in East Africa to
run a coffee plantation on the slopes of Kilimanjaro, around the outbreak of World War I in Europe, and was treated with an arsenic compound as the
result of contracting a social disease. Wikipedia further comments that (see http://en.m.wikipedia.org/wiki/Arsenic_triiodide ):
"Under the name of Liam Donnelly's solution, it was once recommended to treat rheumatism, arthritis, malaria, trypanosome infections, tuberculosis,
and diabetes.[2]"
Here is one cited preparation among others, which the interested reader can browse at http://arsenic.atomistry.com/arsenic_triiodide.html :
"Arsenic Triiodide, AsI3, may be prepared by gently heating a mixture of the elements. The combination is accompanied by evolution of heat and, on
cooling, the triiodide can be obtained by crystallisation from carbon disulphide or xylol. The elements may be heated under a reflux condenser in the
presence of a solvent such as carbon disulphide, ether or chloroform, until the colour due to free iodine has disappeared (the removal of the latter
is accelerated by having a small excess of arsenic present); the solution is then decanted and cooled, and the triiodide which separates is
recrystallised. The product, which is a pharmaceutical preparation, should contain not less than 99 per cent. AsI3."
Apparently the reaction can be exothermic in nature and is performed in the presence of a solvent, like chloroform. Still sounds dangerous especially
without a proper fume hood and equipment.
[Edited on 14-4-2015 by AJKOER]
|
|
|
subsecret
Hazard to Others
Posts: 424
Registered: 8-6-2013
Location: NW SC, USA
Member Is Offline
Mood: Human Sadness - Julian Casablancas & the Voidz
|
|
I hope you find the philosopher's stone.
Fear is what you get when caution wasn't enough.
|
|
|
Bert
|
Thread Moved
15-4-2015 at 06:42 |
quantumcorespacealchemyst
Banned Shitposter
Posts: 213
Registered: 17-10-2014
Member Is Offline
Mood: No Mood
|
|
over days/week/or more, powders mixed in PTFE sealed jar get more clumpy. shaken a little clumps ball up, next day same, next day mostly a mass.
formed to cube(ish) after transfer of a small mass from edge of the main mass, likely to have more unreacted iodine, to another like jar.
edit: the clump was formed into a cube by moving the jar around with enough force to impact deform it off the lid bottom and sides. it is part round
and part flat. the separated part looks more dark purple than the larger mass which is slightly dried out looking compared to after it formed. it
wasn't wet, it had a look like shinyness which is more dried and greyish dark purple. the other bit seperated is still darker purple.
[Edited on 27-7-2015 by quantumcorespacealchemyst]
|
|
|
quantumcorespacealchemyst
Banned Shitposter
Posts: 213
Registered: 17-10-2014
Member Is Offline
Mood: No Mood
|
|
it kind of looks like a stone. it really solidified over time with glistening little crystal spots that were purple, and a dull dryish look to the
rest, it made clinks on the glass, with not a great density, but some change in consistency from outer layer to inner. with a kind of crust like
bread, maybe. it crumbled easily and ground to a powder. on re-weighing and returning to the jar, the jar was agitated and let rest, over some
repetitions, the powder started to cluster up, gumming up and getting a waxy, slightly redder (all still very purple though) look to the outside, the
ball lumps grew each repetition, as the first time.
when the powders were initial mixed, they were left to set for some time, before realizing the reaction was not high in energy, seemingly. over time,
the mass gummed up and through slightly agitating it, it was shook better which gave better clumping and after time there was one sticky lump in the
jar. impacting the jar on my hand in 6 directions gave the initial box shaped lump, with flat top and bottom, and slightly arcing 4 sides. that gummy
malleable like mass, seemingly, dried out, only not in mass but in texture, as when ground recently, it crumbled much easier. the consistency changes
are interesting.
now the lump has been mostly re-crushed with a stir bar and reformed to possibly gum together and be shape able better.
the teflon sheet as a primary lid, and cap buffer for an airtight fit is very useful. it doubles as a weigh plate and can be tared if removing small
parts of the sticky/gummy solution (solid solution? of AsI3 with excess dissolved I2?). i am aware that adding a solvent, or rather adding too much of
the material to solvent to quickly, and/or at to high a temperature, could possibly lead to a uncontrolled reaction. possibly due to sluggish reaction
by mixture in solid solution. i do also want to recollect the excess iodine from the mixture.
the two pictures are after grinding and replacing in jar
and when it was reformed after pelletizing and mashing together with stir bar.
unfortunately i did not document it in the semi stone state. it has small crystals on it, most likely iodine, which were very tiny, flat and shiny and
which were set on the dull crusted mass. it is quite an interesting morphing thing/system. i am interested to see if it's color dulls again.
 
|
|
|
j_sum1
Administrator
Posts: 6335
Registered: 4-10-2014
Location: At home
Member Is Offline
Mood: Most of the ducks are in a row
|
|
Welcome back.
|
|
|
quantumcorespacealchemyst
Banned Shitposter
Posts: 213
Registered: 17-10-2014
Member Is Offline
Mood: No Mood
|
|
the paste becomes more powder like, unsticky, and red when left in the mortar and pestle for a few days. it seems arsenic triiodide remains. more
paste was left in the mortar and pestle from, regrinding and restoring, a smaller test chunk of the material from a different jar.
picture, before regrinding and returning to jar. (paste coating left on mortar and pestle to test color change again)
this was the test reaction, if i remember correctly, to guage the reactiveness of parts of the materials.
[Edited on 1-4-2016 by quantumcorespacealchemyst]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
