Aqua-regia
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 126
Registered: 18-12-2006
Member Is Offline
Mood: No Mood
|
|
purification of 2,6-dichloropyridine-4-carboxilic acid
I am looking to methode purification of 2,6-dichloropyridine-4-carboxilic acid. The product should be white or tan. The route to get
2,6-dichloro-pyridine-4 carboxilic acid was treating citrazinic acid + POCl3 in autoclave. I got a brown powder. Mp. was near to lit. mp. I tried to
purify with meOH esterification, extracted with DCM and desdtillated in vacuo. The result: pruduct idecomposed in 5 hgmm instead boiling.
Any idea?
|
|
Cactuar
Harmless
Posts: 32
Registered: 25-7-2014
Location: Denmark
Member Is Offline
Mood: No Mood
|
|
Maybe (if you work fast) you could wash the methyl esters with alkaline water (~pH 10). Then the mono- and di-phenolic compounds would stay in the
water phase. As I'm sure you know, this would in time cleave the ester as well so don't leave it in there for too long.
|
|
Boffis
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1850
Registered: 1-5-2011
Member Is Offline
Mood: No Mood
|
|
Have you tried dissolving in a suitable solvent and treating with decolourizing carbon?
|
|
Aqua-regia
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 126
Registered: 18-12-2006
Member Is Offline
Mood: No Mood
|
|
What kind of solvent suitable for it? In my opinion isonicotinic acid and their relevant does not dissolve none solvent. If you make the sodium
salt of this one, the water solution cannot filtrate cause the solution is very viscose.
|
|
UnintentionalChaos
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1454
Registered: 9-12-2006
Location: Mars
Member Is Offline
Mood: Nucleophilic
|
|
When you did the methanol esterification, how much acid catalyst did you use? You need to use more than 1eq since the pyridine ties up the first eq.
Thermal decarboxylation on heating wouldn't surprise me.
Department of Redundancy Department - Now with paperwork!
'In organic synthesis, we call decomposition products "crap", however this is not a IUPAC approved nomenclature.' -Nicodem
|
|
Aqua-regia
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 126
Registered: 18-12-2006
Member Is Offline
Mood: No Mood
|
|
The molar ratio:
substrate: 1m meOH 10 m H2SO4 4,45 m
Source: K. Winterfeld: Praktikum der organischen preparativen pharmazeutischen Chemie und Lehrbuch der organisch-chemischen Arzneimittelanalyse Verlag
Theodor Steinkopff Dresden und Leipzig 1965 (221. page.) This recipe was an esterification of isonicotinic acid with etOH.
|
|
unionised
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5109
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
According to this
http://books.google.co.uk/books?id=4ViVUQi7Z60C&pg=PA430...
you can recrystallize it from water
|
|
Mercedesbenzene
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 64
Registered: 4-9-2011
Location: BC
Member Is Offline
Mood: Sub Zero
|
|
Column chromatography would most likely clean it up just fine. The ester might be easier to purify than the acid though due to the tendency for
carboxylic acids to trail on silica
|
|
Aqua-regia
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 126
Registered: 18-12-2006
Member Is Offline
Mood: No Mood
|
|
Thank you all for your advise.
Unionised:
the thing not enough soluble in water for transkristallisation. Less 1g / lit /80 deg.
Mercedes:
I've more than 3 kg crude one. But idea is good.
|
|