metalresearcher
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 737
Registered: 7-9-2010
Member Is Offline
Mood: Reactive
|
|
The Ultimate Thermometer Test: video
Not exactly Chemistry, but as temperature is an important factor in chemistry I checked my thermometers.
For checking the actual values of some temperature measuring devices I read out some of them when putting them into slush which should be exactly zero
degrees C.
<iframe sandbox width="640" height="360" src="http://www.youtube.com/embed/REtomRkjY_0" frameborder="0" allowfullscreen></iframe>
|
|
smaerd
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1262
Registered: 23-1-2010
Member Is Offline
Mood: hmm...
|
|
Just so you know ice can be below 0*C . I suspect that you're slush or slurry is
not exactly homogenous and certainly not all in the melting phase at the exact time of the measurements. Ice only really melts at 0*C and that is with
pure water. Then again there is also the instrumentation error/calibration as well.
Nice set-up with the thermocouple and PID .
|
|
neptunium
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 987
Registered: 12-12-2011
Location: between Uranium and Plutonium
Member Is Offline
|
|
and dont forget that if you live in altitude the result may be flawed as well ....0c is valid at sea level.. with a known preassure ...during a storm
the atmospheric preassure drops and spoilled your results, but this is kinda far for a simple experiment considering that the eye may be mistaken if
not looking exactly at the same level of the alcohol....
this kind of thinking will get you confused and there is really no need for that. nothing is absolute execpt in theory and pure math..
|
|
Swede
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 491
Registered: 4-9-2008
Member Is Offline
Mood: No Mood
|
|
I like your video, thanks for sharing it. I'd guess the systems are showing low (as mentioned earlier) due to contaminants within the melting snow.
If it is in fact snow, it's going to be relatively impure water. You can always try again using frozen distilled water, breaking cubes into small
pieces, then allowing that to melt into a slush, and stabilizing.
My favorite "all-around" lab thermometer is a teflon-coated PT100 RTD which can handle most lab setups short of the really high-temp stuff. I like
easy to read digital displays. It's better than a thermocouple, but not as accurate as a quality liquid thermometer.
|
|