boonga
Harmless
Posts: 8
Registered: 11-8-2011
Location: Australia
Member Is Offline
Mood: Hygroscopic
|
|
Potassium Carbonate from Potassium Sulfate? K2S04 ---> K2C03
Hey guys,
was wondering what would be the easiest/most convenient way to procure (in powder form) potassium carbonate starting from potassium sulfate. I possess
common household ingredients along with a few others; NaOH, NaCL, HCL, H2S04, NaHC03, Na2C03, vinegar etc etc
cheers in advance,
Boong
|
|
|
AndersHoveland
Hazard to Other Members, due to repeated speculation and posting of untested highly dangerous procedures!
Posts: 1986
Registered: 2-3-2011
Member Is Offline
Mood: No Mood
|
|
There is no direct or easy way to prepare potassium carbonate from the sulfate.
One method would be to reduce it to K2S by heating it with charcoal, in the absence of air, then mix with water and finely divided calcium carbonate.
The calcium sulfide will solidify out, leaving K2CO2 in solution. This method, known as the Leblanc process, was the industrial basis for preparing
sodium carbonate (soda ash) before the development of the Solvay process, which is now also obsolete.
|
|
|
not_important
International Hazard
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
In water, mix K2SO4 and Ca(OH)2, gently boil for some time K2SO4 + Ca(OH)2 <=> 2 KOH + CaSO4. Let cool slightly and allow the CaSO4 to settle
out; decant the KOH solution away from that.
The KOH solution will contain some CaSO4 and K2SO4. Evaporate it in a dish, silver is preferred but you can get by with nickle. As the solution
concentrates the sulfates will precipitate out, when a KOH concnetration of around 50% is reached it's time to stop heating. Allow to cool while
limited access to air, then dissolve in alcohol (MeOH or EtOH) and decant away from the sulfates. Treat the solution with CO2 to get K2CO3 + KHCO3,
heating to about 120 C will decompose the bicarbonate.
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination! 
|
|
Quote: Originally posted by AndersHoveland  | There is no direct or easy way to prepare potassium carbonate from the sulfate.
One method would be to reduce it to K2S by heating it with charcoal, in the absence of air, then mix with water and finely divided calcium carbonate.
The calcium sulfide will solidify out, leaving K2CO2 in solution. This method, known as the Leblanc process, was the industrial basis for preparing
sodium carbonate (soda ash) before the development of the Solvay process, which is now also obsolete. |
That is not quite right but the vile and disgusting Leblanc process is the way to go 
|
|
|
bbartlog
International Hazard
Posts: 1139
Registered: 27-8-2009
Location: Unmoored in time
Member Is Offline
Mood: No Mood
|
|
Are you sure about this, or are you generalizing from the similar reaction that goes from K2CO3 to KOH? The same thought had crossed my mind, but I
don't think that CaSO4 is less soluble than Ca(OH)2 the way that CaCO3 is, so I'm not clear what would drive the reaction.
|
|
|
AndersHoveland
Hazard to Other Members, due to repeated speculation and posting of untested highly dangerous procedures!
Posts: 1986
Registered: 2-3-2011
Member Is Offline
Mood: No Mood
|
|
K2SO4 + Ca(OH)2 --> (2)KOH + CaSO4
would probably work.
Before the industrial use of electrolysis, the main method of preparing sodium hydroxide was to react CaO with sodium carbonate and water, the calcium
carbonate eventually precipitating out.
But if it does work, one would wonder why it was not used instead of the LeBlanc process, perhaps CaO was to expensive/difficult to make because of
the high roasting temperatures?
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
