anotheronebitesthedust
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 189
Registered: 24-6-2007
Member Is Offline
Mood: No Mood
|
|
Separating Benzoquinone from Hydroquinone
Recently I Recrystallized 50 grams of benzoquinone from a mixture of green benzoquinone (quinhydrone???) and to say the least it was messy and a pain
in the arse.
Are there any solvents that dissolve hydroquinone and not benzoquinone? Or vice versa?
Here's what I found so far, mostly from Wiki:
Hydroquinone:
6g/100ml H2O
Sparingly soluble in DCE
From what I can interpret it is also sparingly soluble in DCM and Toluene
Benzoquinone:
Sparingly soluble in H2O
Slightly soluble in Petroleum Ether
7g/100ml Toluene
3.6g/100ml DCM
5g/100ml DCE
Soluble in Acetone
Very soluble in Ethanol, Benzene and Diethyl Ether
http://www.freepatentsonline.com/4963234.html
|
|
not_important
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
You'll want to read the article here http://preview.tinyurl.com/2wfxapd
Solutions of hydroquinone and benzoquinone form the bi-molecular complex quinhydrone, a dark green low solubility material. Not real easy to
separate, the best way is to drive the complex to full reduction (for hydroquinone) or oxidation (for benzoquinone) to get just one or the other, then
recrystallise.
|
|
kclo4
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 916
Registered: 11-12-2004
Location:
Member Is Offline
Mood: No Mood
|
|
Quote: | the best way is to drive the complex to full reduction (for hydroquinone) or oxidation (for benzoquinone) to get just one or the other, then
recrystallise. |
I am having the same problem as the OP.
I want only/primarly the hydroquinone. What would an effective method in reducing the benzoquinone be? I'd imagine mixing it will fine Fe and dripping
HCl on it would be one method, however I strongly dislike doing that reaction.
it seem like the product Iron Out, which releases SO2 and contains various bisulfites and dithionite salts of sodium might work?
This, http://www.chemie.uni-regensburg.de/Organische_Chemie/Didakt... shows that sulfurous acid turns benzoquinone to quinhydrone. Would it continue to
turn it into hydroquinone?
|
|
Boffis
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1850
Registered: 1-5-2011
Member Is Offline
Mood: No Mood
|
|
I acquired some very old benzoquinone a few years ago and recently I have been purifying it by steam distillation. This works well but I only get
about 50% recovery and the residue in the flask is the gloop from hell. It is removeable but what a job! I wonder what it can be. Assuming the dark
green colour of the crude benzoquinone is due to quinhydrone what happens when it is steam distilled? Does quinhydone survive steam distillation?
Would be better to reduce or oxidize the crude material first and then process the result. Oxidation would probably be preferable sinc steam
distillation is very simple and efficient.
|
|
pip
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 109
Registered: 19-9-2008
Member Is Offline
Mood: No Mood
|
|
Vanadium pentoxide and hydrogen peroxide methods work well. If it stalls gently heat and it’ll finish sometimes from green to yellow instantly. Your
biggest problem will be the watering eyes that stuff is irritating.
[Edited on 1-2-2021 by pip]
|
|