SsgtHAZMAT
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 60
Registered: 13-12-2006
Member Is Offline
Mood: No Mood
|
|
Neutralizing (large ammounts of) Nitric Acid
Getting rid of Nitric Acid
Yep, I got a new one for you! Nitric Acid. I have a TON of it of unknown purity. That said it is not yellow or red so it is not degrading that I
can tell. I was thinking of digging a big pit filling it with scrap from the metal yard and just dumping it all in. In looking back at it that
seemed like a bad idea.
So what would you chemistry experts use to neutralize it safely, or not so safely?
Thanks!
|
|
evil_lurker
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 767
Registered: 12-3-2005
Location: United States of Elbonia
Member Is Offline
Mood: On the wagon again.
|
|
C-4 in a large open field.
Not all chemicals are bad. Without chemicals such as hydrogen and oxygen, for example, there would be no way to make water, a vital ingredient in
beer.
|
|
Mr. Wizard
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1042
Registered: 30-3-2003
Member Is Offline
Mood: No Mood
|
|
If It was my mess I'd buy enough lime from the lumber yard and start putting them in. Soda ash would be great too, but it's not always available.
Regular masonry lime will work just fine. I'm guessing less than 100 fifty pound sacks, and the by product will be a nitrate fertilizer calcium
nitrate. Keep it out of the water ways, just to keep the nitrates from causing an algae bloom. Cut the bags with a knife and dump them into where the
acid is, or will be. It will get warm, so don't do it all at once. If the solution gets too warm it may boil out some of the acid. Can you safely add
more water to the acid? Is it already in a container or is it a spill?
I did some quick calculation:
CaO +2 HNO3 = Ca(NO3)2 + H2O
40+16 : 2 +28 +96
assuming non hydrated lime, although it is hydrated
56:126 weight ratio on the left side you should need about 900 pounds or 20 50#sacks of lime IF it was pure acid. So save your lumber yard receipt and
take back what you don't use :-) When the Ph is less than 7 you have it covered.
[Edited on by Mr. Wizard]
|
|
evil_lurker
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 767
Registered: 12-3-2005
Location: United States of Elbonia
Member Is Offline
Mood: On the wagon again.
|
|
I had thought of the lime, but I would think that the reaction would be slightly exothermic and not so much of a good idea due to foaming and what
not.
Thats why I suggested just taking it out into a large field and blowing it up... its safe, who gives a shit about where the nitric goes once its in
the ground, and there will be no nitrate salts to dispose of later... I suppose there could be some lime put around it for environmental concerns, but
then again, who cares.
Not all chemicals are bad. Without chemicals such as hydrogen and oxygen, for example, there would be no way to make water, a vital ingredient in
beer.
|
|
SsgtHAZMAT
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 60
Registered: 13-12-2006
Member Is Offline
Mood: No Mood
|
|
Itis in containers. I actually have an amount of NaOH and Na2CO3 but not in the ammounts I really need. One thing I do have an endless supply of is
gypsum.
[Edited on 25-7-2007 by SsgtHAZMAT]
|
|
UnintentionalChaos
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1454
Registered: 9-12-2006
Location: Mars
Member Is Offline
Mood: Nucleophilic
|
|
I'd probably just dump it on an unused field if possible. If you add metal, you will probably overheat and get huge clouds of toxic NO2. You say you
don't have enough NaOH or carbonate base to handle it, plus that would release lots of gas, making it bubble and froth and get everywhere. Exactly how
much are you trying to dispose of? For neutralization, I'd go the lime route, but get Ca(OH)2 (slaked lime) if you can. There won't be an exothermic
reaction. If we have a very large volume, you could dig a pit, dump in a bunch of lime, tip the barrel/barrels or whatever container it is in into the
pit and back off to avoid any fumes. And as someone said, keep it away from surface water.
Department of Redundancy Department - Now with paperwork!
'In organic synthesis, we call decomposition products "crap", however this is not a IUPAC approved nomenclature.' -Nicodem
|
|
not_important
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
lime, either hydrated Ca(OH)2, quicklime if you hydrate it first (exothermic), or CaCO3 including chalk, marble chips, dolomite, whatever. You end up
with crude calcium nitrate of a mix of calcium and magnesium nitrates. That's pretty safe to dump, as already said keep away for waterways and wells;
could even use it as fertilizer if the nitric acid is clean - no heavy metals.
|
|
SsgtHAZMAT
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 60
Registered: 13-12-2006
Member Is Offline
Mood: No Mood
|
|
Keeping it away from water is EASY!
Oh, and I have more than two or three flat beds of the stuff.
|
|
not_important
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
So where are there exposed limestone layers in Iraq? I know there are some in the north, but if there's some near the location of that acid just make
a pit in it and pour the acid into it. Keep netting over it for a few days to keep birds and other animals out, until the acid is fully neutralised.
|
|
16MillionEyes
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 153
Registered: 11-3-2007
Location: 16 Million Eyes, US
Member Is Offline
Mood: No Mood
|
|
One quick solution I can think of besides the already suggested is neutralize it with copious amounts of sodium bicarbonate. It will give off CO2
leaving behind harmless sodium nitrate (can be used as fertilizer). Also, the release of the bubbles will regulate the temperature of the reaction as
evaporation is an endothermic process.
Anyway it's just a suggestion, do what's more economic and easy for you.
|
|
16MillionEyes
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 153
Registered: 11-3-2007
Location: 16 Million Eyes, US
Member Is Offline
Mood: No Mood
|
|
By the way, I'm aware the CO2 isn't the cleanest byproduct but the limited amount produced from this reaction is negligible. Just think about how
humans have been releasing exaggerated amounts of this substance to the atmosphere for almost 150 years and until a few recent years people actually
started noticing harmful changes and not to mention the institutionalized butchering of CO2 regulating living things like trees which disrupt the CO2
cycle. But as I said, do what you want.
|
|
woelen
Super Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 7998
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
If it becomes very hot in the sun, and you have the time and sufficient distance from places where people and animals live, I would let it evaporate.
HNO3 and NOx vapors of course are not good, but the amount, slowly released in the air is only small, compared to the daily output of NOx of all cars,
factories etc. Even natural lightning produces quite some NOx and HNO3. No other chemicals needed, no residues left, which alse need to be disposed
off. You only need time and space.
Practically, you could do it by putting it in big black plastic vessels, or even disperse it on a big black plastic surface.
|
|
Magpie
lab constructor
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
I vote for the slaked lime, Ca(OH)2, procedure as described by Mr Wizard. I have seen a large amount of acid neutralized with Na2CO3 in an industrial
situation and a whole lot of foam is generated. This could be a problem if the neutralizing rate is not carefully regulated. So I'd only use
carbonates or bicarbonates as a 2nd choice.
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|