tito-o-mac
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 117
Registered: 30-6-2007
Member Is Offline
Mood: No Mood
|
|
Help with bursting flasks-overpressure,bad mainteinance or bad qualtiy
I keep using my pressurzed flasks or other containers to store gases when I am heating them. They are of pyrex and I take good care of them, but they
keep breaking or bursting! Can anyone help me with it?
|
|
solo
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3973
Registered: 9-12-2002
Location: Estados Unidos de La Republica Mexicana
Member Is Offline
Mood: ....getting old and drowning in a sea of knowledge
|
|
You are exceeding the pressure ratings of the glass.....scale up to borosilicate glass and will hold up to 60 psi....as used in hydrogenating
vessels......solo
It's better to die on your feet, than live on your knees....Emiliano Zapata.
|
|
bio2
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 447
Registered: 15-1-2005
Member Is Offline
Mood: No Mood
|
|
Maybe if you heat more slowly with a bath or shield
this will help.
At any rate the pressure rating of a 500ml Pyrex round
boiling flask is something like 40-45PSI as near as I can figure.
Joe has run new unblemished ones at 45PSI at less than 100
deg doing an hydrogenation. The hard part is wiring the glass
stopper securely.
Corning or Kimble don't give pressure ratings except on tubing.
I wonder how much more the heavy wall boiling flasks hold
pressure wise compared to the standard wall.
If you look at the Kimble/Kimax pressure versus wall thickness
nomograph it gives some idea even though it is for tubing only.
Solo .....have you used or tested standard round bottom
boiling flasks at 60PSI?
[Edited on by bio2]
|
|