ergoamide
Harmless
Posts: 33
Registered: 16-7-2006
Member Is Offline
Mood: No Mood
|
|
Scaling up microwave reactions
I'm just wondering if anyone could give me any advice as to scaling up microwave reactions. Obviously time would need to be increased as the reaction
size increased but should the time increase be proportional to the reaction size increase? Also the power of the waves emmitted, should they be
increased as the reaction size increases? Any help with this would be great.
Ergo
|
|
Organikum
resurrected
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2336
Registered: 12-10-2002
Location: Europe
Member Is Offline
Mood: frustrated
|
|
Not enough information.
|
|
roamingnome
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 363
Registered: 9-9-2006
Member Is Offline
Mood: No Mood
|
|
consider designing a flow reactor with a residence time in the microwave field.
if the reaction is spinning on plate it would be harder...
to find the hot spot of your microwave place marshmallows around the input wave guide... if a marshmallow is in a hot spot in will inflate quite
quickly! ![:o](./images/smilies/shocked.gif)
the accuracy of this method is still in question though....
|
|
not_important
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
Roamingnome is right - flow reactors are often used to scale up microwave assisted reactions. It's difficult to get uniform power distribution as the
reaction volume increases, unless you lower the RF frequency, going to a relatively small volume with a flowing reaction mass gets around this.
More attention must be paid to the characteristics of the chamber. Standing wave patterns, matching to the power source, and so on, can affect
results.
The clay supported reactions, and other similar ones, don't always scale well. Often these are done will a few millimoles of reactants, the volume of
support matter needed to product product on the scale of many grams can be impractically large' although I remember reading a paper or two on
modifications to address that problem.
Doing online searches should yield some references to scaling up, plus check out the books mentioned for D/L. Off the top of my head, I can't think
of any specific references, and it's too late to be digging through what I've got stored away tonight, but I'll see if I can find something
tomorrow.
|
|
Texium
|
Thread Moved 19-11-2023 at 12:03 |