Foeskes
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 156
Registered: 25-2-2017
Member Is Offline
Mood: No Mood
|
|
Does the upper roller of a van de graaf generator needs to be inside the sphere?
I'm currently building a van de graaf generator and many sources seem to suggest that putting the upper roller and comb inside the topload with a hole
drilled in it makes the result better. Why is this the case and is it really nessesary?
I don't really want to cut the topload(made of ikea bowls) unless nessesary.
[Edited on 6-8-2018 by Foeskes]
|
|
MJ101
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 82
Registered: 14-6-2018
Member Is Offline
Mood: Always Sunny
|
|
IIRC no. But you do need a top and bottom comb to couple charge from the top roller to the sphere.
Take a look here.
https://www.instructables.com/id/900000-volt-Van-de-Graaff-G...
Best of luck.
|
|
Sulaiman
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3631
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
AFAIK the terminal voltage is limited by corona discharge
and corona discharge initiates at sharp edges
or about 3kV per mm radius
e.g. even if no other sharp edges or points,
a two inch diameter roller with no shielding could not sustain more than about 75 kV.
If the roller assembly is shielded inside (for example) an eight inch diameter top load,
then the maximum voltage achievable would be around 300kV.
look carefully at the shape of the topload - there are reasons.
|
|
Texium
|
Thread Moved 27-11-2023 at 12:24 |