RogueRose
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1590
Registered: 16-6-2014
Member Is Offline
|
|
Adapter for flask for filtering?
Are there any adapters that llow the use of regular flasks for filtering instead of having to buy a specific filtering flask with a vacuum port on it?
|
|
greenlight
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 733
Registered: 3-11-2014
Member Is Offline
Mood: Energetic
|
|
The Buchner vacuum filtering flasks are made with much thicker walls to handle the pressure from the vacuum source so that they do not implode..
I have never seen an adapter for a standard conical flask as I don't think they will hold up to the pressure.
Be good, otherwise be good at it
|
|
RogueRose
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1590
Registered: 16-6-2014
Member Is Offline
|
|
Quote: Originally posted by greenlight ![](images/xpblue/lastpost.gif) | The Buchner vacuum filtering flasks are made with much thicker walls to handle the pressure from the vacuum source so that they do not implode..
I have never seen an adapter for a standard conical flask as I don't think they will hold up to the pressure. |
Thanks. I was planning on using a heavy/thick wall flask as I found some 2L for a really good price IMO ($22)
|
|
Sulaiman
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3632
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
You could use one of these http://www.ebay.co.uk/itm/24-40-Glass-Vacuum-Take-off-Adapte...
or
one of these http://www.ebay.co.uk/itm/15ml-Buchner-Funnel-Glass-Separato...
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2689
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
They do make thick walled erlenmeyers for use under vacuum, but they tend to cost a lot, and weigh a lot. Filter flasks are not that pricey, if you
look around, I have some used ones available for $18 each plus postage. If you don't mind small chips or scratched up ones, I have a few I would sell
for less. It is not trivial to adapt an erlenmeyer for filtering, easier to do with a 24/40 joint, those adapters I also have cheap, but work best
for small Buchners, not big ones, too unstable.
|
|